Rack Front

d.Position the ear of the rear-mount rail against the rear exterior of the equipment rack, and align the top and bottom holes in the ear of the rail with the threaded holes (or cage nuts) in the equipment rack.

e.Using two 10-32 x 0.5-inch Phillips pan head screws, attach the ear of the rail to the rear of the rack. Insert the screws from the outside of the rack, pointing toward the front of the rack (refer to Figure 11).

RACK REAR

	(2) SCREWS,	(2) SCREWS,
		10-32 X 0.5-INCH
	10-32 X 0.5-INCH
		PHILLIPS PAN HEAD
	PHILLIPS FLAT HEAD

FRONT-MOUNT RAIL

REAR-MOUNT RAIL

Figure 11. Attaching Support Rails

6.Repeat step 5 for the second support rail assembly.

7.Tighten the 8-32 x 0.375-inch Phillips truss head screws that were attached to the front- and rear-mount rails in steps 2 and 3.

8.Place the unit onto the support rails by sliding the chassis brackets onto the rails (refer to Figure 12). The unit should slide in and out of the rack easily.

WARNING: When sliding the unit out of the rack, be careful not to let the unit fall out of the rack.

Figure 12. Mounting the Transmitter/Receiver into a Rack

12	C2652M (1/08)