Connections, Pin Number | Pelco C2652M, FR8332 guide

CONNECTIONS

Connections to the FT8332 transmitter/FR8332 receiver are made on the rear panel of the unit (refer to Figure 14).

FIBER OPTIC CABLE

RELAY WIRING

COAXIAL CABLES,

(REFER TO TABLE A)

POWER CONNECTION

CHANNELS 1-8

CHANNELS 9-16

CHANNELS 17-24

CHANNELS 25-32

FOR EPS5000-120

POWER SUPPLY

POWER CONNECTION

FOR STAND-ALONE

UNIT

Figure 14. FT8332 Transmitter/FR8332 Receiver Connections

As illustrated in Figure 14, connections to the transmitter/receiver consist of the following:

•Up to 32 video input connections (transmitter only)

•Up to 32 video output connections (receiver only)

•Fiber connection

•Relay connection. Table A lists relay pin assignments.

Table A. Relay Pin Assignments

Pin Number

Relay Wiring

1Common (C)

2Normally Closed (NC)

3Normally Open (NO)

•Power connection

NOTES:

–A 12 VDC or 24 VAC power supply can be used to power the transmitter/receiver when used as a stand-alone unit. A 12 VDC power supply is provided. If a 24 VAC power supply is used, the power supply must be a Listed Direct Plug-In Power Unit marked as Class 2 and rated as 24 VAC, 1.5 A (minimum output).

–A 12 VDC EPS5000-120 power supply is used when the unit is mounted into a standard 19-inch EIA rack. Up to two transmitters/ receivers can connect to the EPS5000-120 power supply using the two power cables provided with the power supply. Refer to the EPS5000-120 External Power Supply Installation manual for additional information.

–In extreme temperature conditions, it is recommended that an industrial-rated outdoor power supply be used.

14	C2652M (1/08)