Installation
To install the
1.Run 24 VAC power, video (coaxial or UTP), and camera control wiring to the mounting location. If you are using coaxial video, do not attach a BNC connector to the cable until step 5.
2.Thread the 24 VAC power, video (coaxial or UTP), and control wiring through the large access hole in the adapter plate. Then attach the adapter plate to the mounting surface using either the top/bottom or left/right pair of mounting holes. (The top/bottom pair is shown in Figure 1.)
NOTE: If mounting to anything other than a junction box, select appropriate mounting hardware for the mounting surface
.
Figure 1. Mounting the Adapter Plate
C2234M (2/07) | 3 |