Go-Video DDV9000 manual Sync Editing

to stop the tape in Deck 1.

The Copy Tape Button makes

Sync Editing a snap

4 Play the source tape in Deck 1 to the beginning of the first scene (in our example this is tape counter position 0:01:08). Press the BEGIN key to mark the beginning of the scene.

5 Play the tape to the end of the scene (in our example this is tape counter position 0:03:34). Press the END key to mark the end of the scene.

Note: After you program each scene, the next scene number will blink indicating it’s ready to be programmed.

6 Press the number for the next scene you want to program (in our example, scene 2).

7 Repeat steps 4-6 until all scenes are programmed. 8 Press STOP

Note: You cannot eject the tape in Deck 1 with the remote control if there are scenes in the Edit List.

9 Load a blank tape into Deck 2.

10 Press the COPYTAPE key. The Dual-Deck VCR will automati- cally copy each scene from Deck 1 to Deck 2 in the order programmed.

11 When editing is complete, stop Deck 2.

Sync Editing

You can also perform assembly editing manually, also known as Sync (Synchronized) Editing.

Note: For best results when Sync editing, be sure to:

	• Turn on the On-Screen Display (p.12)
	• Turn off EZ-Copy (p.19)
	• Turn off Auto Play (p.23)
1	Insert the source tape into Deck 1.
2	Insert the target tape into Deck 2.
3	Press				to select Deck 2.
			DECK 2
4	Play the target tape in Deck 2 to approximately 3
	seconds after the end of the last frame of the last scene,
	then press						.
5					PAUSE/STILL
	Press				for Deck 2. This puts the deck into Record
			RECORD
6	Pause		mode.
	Press				to select Deck 1.
			DECK1
7	Play the source tape in Deck 1 to the beginning of the
	desired scene and press									. The Copy Tape button
								PAUSE/STILL
8	will blink.
	Push					to begin editing.
		COPYTAPE
9	The source tape will copy onto the target tape until you
	press	STOP		on Deck 2, or					COPYTAPE	again to make additional

Sync Edits.

CHAPTER 7 - EDITING FEATURES 35