JVC HR-J595EK manual Playback, Load a Video Cassette, Stop & Eject

Page 24

24

basic features

Playback

before you start

Turn the TV on

Tune the TV to your Video Channel or to its AV mode

ntsc tapes

Some TVs will shrink the picture and place black bars at the top and bottom of the screen. This is not a malfunction but you may lose some on-screen information

The picture may roll up or down. Correct this by adjusting the vertical hold on the TV set

The counter and tape remaining times will be incorrect

The picture will be distorted during search, still or frame-by-frame playback

Playback is the most basic operation possible with your VCR. Audio-visual information recorded on a cassette will be played back on your TV screen just like a broadcast programme.

Load a Video Cassette

Make sure that the window side of the cassette is facing up and the spine label is facing away from the VCR. Insert the cassette as shown in the diagram below; donÕt use too much force. If the VCR was turned off before you inserted the cassette, the power will come on automatically.

The counter on the TV screen will reset to read Ô0:00:00Õ. If the record safety tab on the video cassette has been removed, playback begins automatically.

Play

If the cassette that you inserted does not start playing automatically, press the . button on the VCR or the Remote Control.

¥If the tape reaches its end during playback, the VCR stops playback, rewinds the tape and ejects the cassette, then enters the standby mode automatically.

Stop & Eject

stop Press the ¤button on the VCR or the Sbutton on the Remote Control once to stop playback.

eject Press the ¤button on the VCR a second time or the 0button on the Remote Control to eject the cassette from the VCR. The cassette will take about 6 seconds to appear once the ¤button has been pressed.

Page 23 Page 25
Image 24
Page 23 Page 25
Contents HR-J595EK Safety Precautions If in doubt Ñ consult a competent electricianMoisture Condensation Some DoÕs And DonÕts On The Safe Use Of EquipmentContents Front panel Rear panel Display Remote control Diagram Key Front Panel Rear Panel Remote ControlWelcome to JVC Getting Everything ReadyScart and rf Plug&Play Setup Start Plug&Play SetupCheck the Results Finish OffPlug&play setup Initial Settings Access Video Channel Set Mode Exit Video Channel Set ModeVideo Channel Set Set channel on TVSetting the language Language SetSetting the Clock Clock SetAuto Channel Setup Tuner SetManual Channel Setup PR SETChange Station Name Delete a ChannelChange Station Preset Position Fine-Tuning Stored Channels TV Station ID GuideTV Station Channel Number Guide BBC1 BBC2 ITV CH4 CH5Basic Features Playback Load a Video CassettePlay Stop & EjectVideo Heads Cleaning Rewind and Fast ForwardPlayback Features Pause During PlaybackSingle Frame Movement Slow MotionVariable Speed Search High Speed SearchSkip Search Recording Choose a ProgrammeSet the Tape Speed Start RecordingResetting the Counter Display Tape Position/Time CounterChange Display Information Instant Timer Recording Get to the Video Plus + Screen Enter the PlusCode NumberEngage Timer Mode Return to Normal ScreenGet to the Programme List Enter Programme DetailsIntelligent LP Recording Check, Cancel & Change Programmes Using the *and Tbuttons and press OKBasic features Advanced Features Picture Quality Manual TrackingPicture Control Sound Modes Nicam Stereo and Bilingual BroadcastsSoundtrack Selection Advanced features Editing Using Another VCR EditingEditing From a Camcorder Start recorder Press TOther Functions On-Screen Display OSDRewind Power Off Ez Easy Power OffEz Easy Repeat Playback Memory Stop Facility Colour SystemCompatibility Child LockConnection to a Stereo System Questions and Answers PlaybackTroubleshooting Symptom Possible CauseRecording Other Problems List of Terms Memo Memo Memo HR-J595EK
Top Page Image Contents