JVC HR-VP683U manual Changing Remote Control Code, Unplug VCR, Set remote control code for Remote

Changing

Remote Control

Code

4

2–1

1	2	3
			2	2–2, 3
4	5	6
7	8	9
	0		4

1

3 2–3

EN 41

This Remote is capable of transmitting two control codes; one set to respond to A code control signals and another set to respond to B code control signals.

This Remote control is preset to send A code signals because your VCR is initially set to respond to A code signals. You can easily modify your VCR and the Remote to respond to B code signals.

When using two JVC VCRs, set two VCRs and their Remotes to different codes, so that you can operate these VCRs separately.

1 Unplug VCR

Unplug the AC power cord from the AC outlet.

2 Set remote control code for Remote

1 Press and hold A/B.

2 Press the Number key “2”.

3 Press OK, and release A/B.

● The Remote now can transmit B code control signals.

3 Plug in VCR

Plug the AC power cord back into an AC outlet.

4 Turn on VCR

Press POWER on the Remote.

●The VCR now responds to B code control signals.

●To set the Remote and the VCR back to A code control signals, repeat the same procedure as shown above except pressing the Number key “1” in step 2.

To control two VCRs with the same Remote

You can control two JVC VCRs by switching the remote control code for the Remote between A and B (☞ step 2), keeping two VCRs to different control codes.

●Press the Number key “1” for A code control signals and the Number key “2” for B code control signals. (To change only the remote control code for the Remote, DO NOT perform steps 1, 3, and 4 .)

(Ex.) To set Remote to B code:

MBR SET

A/B

	E
2	NTER/O		SD	Release
	3	OK

Hold	Press in succession
down