24ENTIMERRECORDING
SHOWVIEW
Timer
Recording
Before performing SHOWVIEW timer recording:
●Be sure to read "SHOWVIEW Setup" (☞ pg. 10).
●Insert a cassette with the safety tab in place. The recorder will come on automatically.
●Turn on the TV and select the VIDEO channel (or AV mode).
¢ | ¢ |
q
Á | 1 |
|
|
|
|
|
|
|
|
|
|
1
2
ACCESS TIMER PROGRAMMING SCREEN
Press PROG.
TIMER PROGRAMMING
[0 – 9] : SHOWVIEW
[MENU] : MAIN MENU
The front display panel looks like this:
ENTER SHOWVIEW NUMBER
Press the NUMBER keys to | SHOWVIEW | |
enter the SHOWVIEW | ||
number of a programme | 1 2 3 4 5 6 7 8 |
|
|
| |
you wish to record. |
|
|
●If you make a mistake, press CANCEL to
backspace and then |
|
[0 – 9] = | |
input the correct number. | [CANCEL] : DELETE |
The SHOWVIEW number | [MENU] : EXIT |
|
you enter appears on the front display panel:
The display panel can only show 4 digits at a time.
ACCESS SHOWVIEW
PROGRAM SCREEN
1 | 2 | 3 |
|
4 | 5 | 6 |
|
NUMBER |
|
|
|
7/ | 8 | 9 | CANCEL |
:PDC/VPS |
|
| |
0 |
| 4 | |
|
| ||
PROG. CHECK |
|
|
|
2 |
|
|
|
3
Press OK, and the
SHOWVIEW Program screen appears (if you’re just starting out, “P1” appears).
The display panel shows the programme start time. Pressing PROG. CHECK changes the display to the programme stop time, then the date and channel position.
– P1 –
SHOWVIEW 123456789
START STOP 21:00 = 22:00
SP | ON |
DATE | TV PROG |
25.121 ARD
: OK
1 | 3 | Á |
¦ | 7 | 8 |
1 | 4 | ¢ |
|
PROG.
3
OK
SP
IMPORTANT
Be sure to confirm the setting of PDC/VPS recording.
●If " ON" is displayed on the screen or " " is lit on the display panel, PDC/VPS is set to ON.
●If " OFF" is displayed on the screen or " " is not lit on the display panel, PDC/VPS is set to OFF.
To change the setting, press : PDC/VPS (NUMBER key "7").
☞ "PDC/VPS Recording" on page 29.
●Make sure the channel position number you wish to record is displayed; if not, see "SHOWVIEW Setup" on page 10 and set the Guide Program number for that SHOWVIEW number correctly.
●If the number you entered is invalid, "ERROR" appears on the screen and "Err" appears on the display panel. Press CANCEL to backspace and input a valid SHOWVIEW number.
●If "ERROR=GUIDE PROG" appears on the screen, see "ATTENTION – Regarding Guide Program Number Set" on page 25.