JVC HR-J638E/EH Enter Showview Number, Close Menu, When Using a Satellite Tuner, Preparation

ENTER SHOWVIEW
NUMBER
Press OK, and a cursor
appears above “GUIDE	12345 5
4 PROG”. Then, using the
	GUIDE PROG	TV PROG
NUMBER keys, input the
ShowView number (found	1	1
in most TV listings) of a
program scheduled to be	[0 – 9] =
broadcast on each station
on the list from step 1,	When entering a ShowView
starting at the top. If you	number for ARD
enter the wrong number,
press CANCEL and input the correct number.

	ENTER CHANNEL POSITION
	NUMBER
4	Press OK and the display
	under “TV PROG” begins
		250	39
5 blinking.
		GUIDE PROG TV PROG
	If the blinking number
	under “TV PROG” agrees
	with the channel
	position . . .	[5°] =
	. . . press OK.
	If the numbers do not agree . . .
	. . . input the channel position using PUSH JOG%Þ or
	the NUMBER keys, then press OK.

●If you input the ShowView number of a program that has already aired, “ERROR” appears on screen for a few seconds. Input the correct ShowView number.

●Repeat steps 4 and 5 as necessary.

CLOSE MENU

6 Press CH SET and selection is complete.

If you already know the Guide Prog. number for a station . . .

1– After step 3, press PUSH JOG %.

●The GUIDE PROG number begins blinking.

2– Enter the Guide Prog. number using the NUMBER keys or PUSH JOG%Þ, then press PUSH JOG %.

●The TV PROG number begins blinking.

3– Enter the channel position using the NUMBER keys or PUSH JOG%Þ, then press PUSH JOG% .

●Repeat 2 and 3 as necessary. 4– Press CH SET.

EN21

When Using A Satellite

Tuner

Satellite Antenna		Aerial or Cable
Ex. 1	Ex. 2
Satellite	Satellite
	Tuner and
Tuner
	Decoder
AV2 IN/DECODER

AV2 SELECT Switch

TV Receiver

Preparation

1– Connect the satellite tuner to the AV2 IN/DECODER connector on the rear of your recorder.

2– Set the AV2 SELECT switch to "AV2".

To Record Satellite Broadcasts . . .

1– Select the appropriate channel on the satellite tuner.

2– Press NUMBER key "0" to set your recorder's input mode to "AUX2".

3– Start recording (☞ pg. 14, steps 3 – 6).

To Record Satellite Broadcasts Using ShowView Timer Recording . . .

1– Perform Guide Prog. Number setting.

●In step 5 in the left column, press NUMBER key "0" to set "TV PROG" to "AUX2".

2– Perform ShowView Timer Recording (☞ pg. 22).

To Record Satellite Broadcasts Using Regular Timer Recording . . .

1– In step 6 on page 24, press TV PROG. +/– to set the channel position to "AUX2".

NOTES:

●When timer-recording a satellite programme, first set the satellite tuner to the appropriate channel before the selected programme begins and then set the satellite tuner's timer. If your satellite tuner does not have a timer, leave it switched on.

●If your recorder's front panel VIDEO and/or AUDIO connec- tors are being used, they take priority and "AUX2" cannot be selected. Make sure no cables are connected to the front panel connectors when performing this procedure.