JVC HR-J638E/EH Select NEW Station, Switch Stations, Select Channel to, Fine-Tune, Perform Tuning

32EN

USINGTHECONFIRMATIONSCREEN (cont.)

Perform steps 1 and 2 of "Storing Channels Manually" on page 31 to access the Confirmation screen before continuing.

Set Stations (A)

1	SELECT ITEM
	Press PUSH JOG%Þ%%until the item you want begins
	blinking. Then press OK twice and the station’s name
	(ID) begins blinking.

2	SELECT NEW STATION
	Press PUSH JOG%Þ until the new station’s name (ID)
	you want to store begins blinking.
	Registered station names (☞ pg. 33) appear as you
	press PUSH JOG%Þ.

3	SWITCH STATIONS
	Press OK.
	● Repeat steps 1 through 3 as necessary.
	CLOSE CONFIRMATION
4	SCREEN
	Press CH SET.

Fine-Tuning Channels

Already Stored

	SELECT CHANNEL TO
1	FINE-TUNE
	Press PUSH JOG%Þ%%until the channel you want to
	tune begins blinking.
	ACCESS MANUAL CH. SET
2	SCREEN
	Press OK three times. The Manual Ch. Set screen
	appears.
3	PERFORM TUNING
	Press PUSH JOG%Þ until the picture is its clearest.
	Then press OK.
	● The Confirmation screen appears.
	● Repeat steps 1 through 3 as necessary.
	CLOSE CONFIRMATION
4	SCREEN
	Press CH SET.

Set Stations (B)

NOTE:

First perform step 1 of the above procedure.

2

3

4

SELECT STATION NAME CHARACTER

Press PUSH JOG % and the first letter of the station name begins blinking.

ENTER NEW CHARACTER

Press PUSH JOG%Þ to cycle through the characters
(A–Z, 0–9, –, , +, (space)) and stop when the
desired one is*indicated,]	then press PUSH JOG%to

enter. Enter the remaining characters the same way (maximum of 4).

After entering all characters, press OK.

●Repeat steps 1 through 3 as necessary.

● If you make a mistake, press PUSH JOG% until the incorrect character begins blinking. Then enter the correct character by pressing PUSH JOG%Þ .

CLOSE CONFIRMATION SCREEN

Press CH SET.