JVC HR-J673EU instruction manual About Ntsc Playback

		EN 39
		* The default setting is bold in the table below.
8 L-2 SELECT		Set this function to the appropriate mode depending on the
L-2:	To use this recorder as the recording	type of unit connected to the rear panel AV2 (L-2) IN/
	deck with the player connected to	DECODER connector of the recorder.
	the AV2 (L-2) IN/DECODER	NOTES:
	connector, or to use the satellite
	receiver connected to the AV2 (L-2)	● If you have a decoder connected to the AV2 (L-2) IN/DECODER
	IN/DECODER connector.	connector, be sure to set “L-2 SELECT” back to “DECODER”
DECODER:		after editing.
	To use a decoder connected to the
		● If you’re not connecting a decoder to the AV2 (L-2) IN/
	AV2 (L-2) IN/DECODER connector.
SAT:		DECODER connector, leave “L-2 SELECT” set to “L-2”.
	To view a satellite programme with
		● The default setting is “L-2”; if the recorder’s memory backup has
	the TV set while the recorder is	expired due to a power cut or because the AC was removed
	turned off. ( pg. 33)	from the recorder, “L-2” will be automatically selected when the
		power is restored to the recorder. If you are using a decoder, be
		sure to set “L-2 SELECT” back to “DECODER”.
		● When “L-2 SELECT” is set to “SAT”, “SAT” appears on the
		screen or front display panel instead of “L-2”.
8 COLOUR SYSTEM		You can play back PAL, NTSC and MESECAM tapes, or
PAL/NTSC:	To record PAL signals, or play back a	record PAL and SECAM* signals on this recorder. Select the
	PAL or NTSC tape.	appropriate colour system.
MESECAM:	To record SECAM signals, or play	* SECAM signals will be recorded as MESECAM on this recorder;
	back a MESECAM tape.	MESECAM is the designation for tapes with SECAM signals that
		have been recorded on a MESECAM-compatible PAL video
		cassette recorder.
		NOTES:
		About NTSC Playback
		● Some TVs shrink the picture vertically and place black bars at
		the top and bottom of the TV screen. This is not a malfunction
		on the part of either the video recorder or the TV.
		● The picture may roll up and down. This can be corrected using
		the V-HOLD control found on some TVs. (This cannot be
		corrected if the TV does not have a V-HOLD control.)
		● The counter and tape remaining time readings will be incorrect.
		● During search, still, or frame-by-frame playback, the picture will
		be distorted, and there may be a loss of colour.
		● Depending on the type of TV, the top and bottom portions of
		superimposed displays may be cut off during NTSC playback.