JVC HR-J712EU Access Mode Set, Select Picture, Control Set Mode, 16ENPLAYBACKcont, Start Playback

16ENPLAYBACK(cont.)

Repeat Playback

Your video recorder can automatically play back the whole tape 50 times repeatedly.

Picture Control

This feature helps you to adjust the playback picture quality according to your preference. *The default setting is "AUTO."

1		START PLAYBACK
	Press PLAY.
2		ACTIVATE REPEAT PLAYBACK
	Press PLAY and hold for over 5 seconds, then release.
		● The Play indicator ( ) on the display panel blinks
		slowly.
		● The tape plays 50 times automatically, and then
		stops.
3		STOP PLAYBACK
	Press STOP at any time to stop playback.

NOTE:

Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.

Soundtrack Selection

Your video recorder is capable of recording three soundtracks (HI-FI L, HI-FI R and NORM) and will play back the one you select.

During Playback

Pressing AUDIO on the remote control changes the soundtrack being played back as follows:

TRACK			USE
On-Screen Display
	HI FI		For Hi-Fi stereo tapes
L		R
L	HI FI		For main audio of Bilingual tapes
	HI FI		For sub audio of Bilingual tapes
		R
NORM			For audio-dubbed tapes
	HI FI		For audio-dubbed tapes
NORM

NOTES:

●"HIFI L R" should normally be selected. In this mode, Hi-Fi stereo tapes are played back in stereo, and the normal audio track is played back automatically for tapes with only normal audio.

●For instructions on recording stereo and bilingual programmes, refer to page 19.

●"O.S.D." must be set to "ON" or the on-screen displays will not appear (☞ pg. 9).

	ACCESS MAIN MENU
	SCREEN
1 Press MENU.
	ACCESS MODE SET
	SCREEN
Move the highlighted bar (pointer) to "MODE SET" by
2 pressing %Þ, then press OK or #.
	SELECT PICTURE
	CONTROL SET MODE
	Move the highlighted bar	MODE SET
	(pointer) to "PICTURE	B. E. S. T.	ON
	CONTROL" by pressing
		PICTURE CONTROL	AUTO
3 %Þ, then press OK or #to		AUTO TIMER	OFF
	select the desired mode.	O. S. D.	ON
		DIRECT REC	ON
	AUTO: Provides	AUTO SP=LP TIMER	OFF
	optimised picture	POWER SAVE	OFF
		NEXT PAGE
	benefits of B.E.S.T.
		[5°] =
	Picture System.	[MENU] : EXIT
	Normally select
	AUTO.
	EDIT: Minimizes picture degradation during editing
	(recording and playback).
	SOFT: Reduces image coarseness when viewing
	overplayed tapes containing a lot of noise.
	SHARP: Clearer, sharper-edged picture when viewing
	images with lots of flat, same-coloured surfaces
	such as cartoons.

NOTES:

●When you select EDIT, SHARP or SOFT, the selected mode will not change until you select again.

●When you select EDIT to dub tapes, be sure to select AUTO after you finish dubbing the tapes.

RETURN TO NORMAL

SCREEN

4 Press MENU.

NOTES:

●When B.E.S.T. is OFF, "PICTURE CONTROL" switches automatically from AUTO to NORM.

●Select EDIT when you are dubbing tapes. Refer to page 30.