JVC HR-J712EU 38EN, Select Band, Input Channel, Access Confirmation, SUBSIDIARYSETTINGScont

38EN

SUBSIDIARYSETTINGS(cont.)

NUMBER

1

1 2 3

4 5 6

7 8 9

0

?

2

4

	SELECT BAND
Press %Þ to change the
	band between CH (regular)
	and CC (cable), then		PR	CH ID	FINE DECODER
4 press #.			12	CH01 – – – –	+/– OFF
			[5°] : SELECT
			[°°] : CURSOR +=
				: OK
			[MENU] : EXIT
		The blueback screen and the
		programme currently being
		broadcast by the selected channel
		appear alternately for 8 seconds
		each.
	INPUT CHANNEL
Press the NUMBER keys to input the channel number you

ENU

3 OK

Storing Channels Manually

Store channels that were not stored during Auto Set Up (☞ pg. 4), Preset Download (☞ pg. 6) or Auto Channel Set (☞ pg. 36).

1		ACCESS MAIN MENU
	Press MENU.
		ACCESS CONFIRMATION
2		SCREEN
	Press %Þ to move the highlight bar (pointer) to
		“MANUAL CH SET”, then press OK or #. The Confir-
		mation screen appears.
3		SELECT POSITION
	Press %Þ @ #until an		(Ex.) To store in position 12.
		open position in which		PR	CH	ID	PR	CH ID
		you want to store a	02		CDB	SKY1	09	55 WEST
			01		25	ARD	08	C26 E-SP
		channel begins blinking,	03		10	ZDF	10	C24 SAT1
		then press OK. The
			04		C65	RAI1	11	C23 OSF
		Manual Channel Set		05	C31	BBC1	12	– – – –
			06		C32	BBC2	13	– – – –
		screen appears.
			07		C33	3SAT	14	– – – –
				[5°°°]
				=		: EDIT
				= [X] : DELETE
				[MENU] : EXIT
			The blueback screen and the
			programme currently being
			broadcast by the selected channel
			appear alternately for 8 seconds
			each.

5 want to store.

●Input "0" before any single number entries.

●To input the registered station name (ID – ☞ pg. 41), press #until "----" (ID setting) begins blinking, then press %Þ.

●For fine tuning adjustment, press # until "+/–" begins blinking, then press %Þ. While tuning, “+” or “–” appears.

●When storing a channel that sends scrambled broadcasts, press # until "OFF" (Decoder setting) blinks, then press %Þ to set "DECODER" to "ON" ("OFF" is the default setting).

●When "AV2 SELECT" is set to "AV2", the "DECODER" setting cannot be changed (☞ pg. 31).

ENTER NEW CHANNEL INFORMATION

6 Press OK and the Confirmation screen appears.

●Repeat steps 3 through 6 as necessary.

CLOSE CONFIRMATION SCREEN

7 Press MENU.

●To change positions, see "Change Station Channel Position" (☞ pg. 39).

●If you wish to set station names other than the ones registered in your recorder, ☞ "Set Stations (B)" on page 40.

ATTENTION

Guide Program numbers are not set when channels are stored manually. If an attempt is made at timer program- ming with SHOWVIEW in this state, the “GUIDE PROG SET” screen appears; set the Guide Program numbers on this screen. ☞ “ATTENTION – Regarding Guide Program Number Set” on pg. 23.

Or perform “Guide Program Number Set” (☞ pg. 46).