FL-1 OUTPUT
Editing
L-1 OUTPUT Setting
The L-1 IN/OUT connector delivers either a composite signal (regular video signal) or a Y/C signal (a signal in which the luminance and chrominance signals are separated). Set L-1 OUTPUT to the appropriate mode depending on the type of unit connected to the rear panel L-1 IN/OUT connector of this VCR.
get to the output/input set screen Press m. Move the highlight bar to
OUTPUT/INPUT SET using the Aand Bbuttons and press | 3 | OK / | (or E). |
| | |
select mode Move the highlight bar to L-1 OUTPUT using the Aand Bbuttons.
Press | 3 | OK / | (or E) to select the desired mode: |
| | |
FOR L-1 OUTPUT | | L-2 INPUT | VIDEO |
| | | |
• VIDEO : If a connected device’s input is | | | | |
compatible only with regular | | [1] a k | | |
| [MENU]: EXIT | | |
video signals, set to VIDEO. | | | | |
| | | |
•S-VIDEO : If a connected device’s input is compatible with Y/C signals, set to
S-VIDEO. This setting will let you take advantage of higher-quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)
return to normal screen Press m.