JVC HR-S6955EK manual Editing Using Another VCR

advanced features

39

Editing Using Another VCR

connect up Connect the player’s 21-pin SCART connector to the recorder’s 21-pin SCART connector as illustrated.

AWhen using your VCR as the player ...

... connect its L-1 IN/OUT connector to another VCR.

BWhen using your VCR as the recorder ...

... connect its L-2 IN/DECODER or L-1 IN/OUT connector to another VCR.

set vcr’s input mode The recording VCR mode must be set to AUX. If this VCR is the recorder, press AUX and/or PR to select L-1(if you’ve used the L-1 IN/ OUT connector) or L-2(if you’ve used the L-2 IN/DECODER connector). If this VCR is the player, set O.S.D. to OFF. (☞ pg. 42)

set edit mode See Picture Control on page 31.

start source vcr Engage its PLAY mode.

start recording vcr Engage its RECORD mode.

NOTES:

•All necessary cables can be obtained from your dealer.

•For Y/C signal input/output, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.

•When you set PICTURE CONTROL to EDIT to dub tapes (☞ pg. 31), be sure to select AUTO (or NORM when B.E.S.T. is set to OFF) after you finish dubbing the tapes.