JVC HR-S7600EK setup guide Remote Con- trol Functions, SET Remote Control, Code, RE-SUPPLY Power

30ADVANCEDOPERATIONS(cont.)

Remote Con- trol Functions

Remote A/B Code Switching

The remote control is capable of controlling two JVC video recorders independently; one set to respond to the remote control’s A code control signals and another set to respond to B code control signals. The remote control is preset to send A code signals because your video recorder is initially set to respond to A code signals. You can easily modify your video recorder to respond to B code signals.

VCR

NUMBER "1"

1

2

1

2

– –:– –

1 2 3

4 5 6

7 8 9

0

3

4

4

3

	1	REMOVE POWER SUPPLY
		Unplug the mains power cord from the mains outlet.
		SET REMOTE CONTROL
	2	CODE
		Press and hold VCR on the remote control for over 2
		seconds, press the NUMBER key "2" and then press OK.
	3	RE-SUPPLY POWER
		Plug the mains power cord back into the mains outlet.
OK		TURN THE RECORDER ON
	4	Press	on the remote control. The recorder will now
		only respond to B code signals.

NOTE:

￿

To set the recorder back to respond to A code signals, repeat the same procedure as shown above except pressing NUMBER key "1" instead of "2" in step 2.