JVC HR-S7600EK setup guide Access Manual, Channel SET Screen, Select NEW Station, Switch Stations

50SUBSIDIARYSETTINGS(cont.)

Set Stations (A)

Set station names that are registered in your recorder.

Perform steps 1 and 2 of "Storing Channels Manually" on page 48 to access the Confirmation screen before continuing.

1	SELECT ITEM
	Press %Þ @ #until the item you want begins blinking.
	ACCESS MANUAL
2	CHANNEL SET SCREEN
	Press OK twice.
3	SELECT NEW STATION
	Press # until the station
	name (ID) begins blinking,
	then press %Þ until the	PR CH ID FINE DECODER
	new station’s name (ID)	06 CH45 – – – – +/– OFF
	you want to store begins
	blinking.
	Registered station names	[5°] : CHANGE ID
		[°°] : CURSOR +=
	(☞ pg. 51) appear as you
		: OK
	press %Þ.	[MENU] : EXIT
4	SWITCH STATIONS
	Press OK.
	● The Confirmation screen appears.
	● Repeat steps 1 through 4 as necessary.
	CLOSE CONFIRMATION
5	SCREEN
	Press MENU.

Set Stations (B)

Set station names other than the ones registered in your recorder.

Perform steps 1 and 2 of "Storing Channels Manually" on page 48 to access the Confirmation screen and then perform steps 1 and 2 of "Set Stations (A)" on the left before continuing.

SELECT STATION NAME

CHARACTER

1	Press # until the first letter
	of the station name begins
	blinking.		PR	CH ID	FINE DECODER
			06	CH45 BBC1	+/– OFF
			[5°] : A-Z, 0-9
			[°°] : CURSOR +=
				: OK
			[MENU] : EXIT
	ENTER NEW CHARACTER
	Press %Þ to cycle through the characters (A–Z, 0–9, –,
	*, +, (space) ) and stop when the desired character
2 is indicated, then press		#to enter. Enter the remaining
	characters the same way (maximum of 4).
	After entering all characters, press OK.

●The Confirmation screen appears.

●If you make a mistake, press @ until the incorrect character begins blinking. Then enter the correct character by pressing %Þ.

CLOSE CONFIRMATION SCREEN

3 Press MENU.