JVC HR-S5967EK, LPT0768-001B manual Three-Step Quick Start, Auto Setup

10

three-step quick start

Three-Step Quick Start

Auto Setup

before you start

Check that the VCR is turned off and no cassette is inserted

Load the battery into the Remote Control

Refer to the Remote Control diagram on pages 6–7

START AUTO SETUP

Press the obutton. If ‘Auto’ appears on the display panel, press OK (or E).

what will happen? The display panel on the front of the VCR will show the word ‘Auto’. Do not press any button on the VCR or the Remote Control.

S-VHS	VCR	The VCR is automatically setting up the tuner
		channels, clock, the VIDEO Plus+ system assigned
		Guide Program numbers and the video channel.
		This only happens the first time that the VCR is
Auto Setup is running: don’t
		turned on.
touch any buttons

Unless indicated otherwise, use the buttons on the Remote Control

Check that the connection is completed

AUTO SET

PLEASE WAIT

[MENU]: EXIT

rf and scart connection If you have chosen to connect the VCR to the TV with both the RF Cable and a 21-pin SCART Cable (not provided) and the TV set is in its AV mode (see the TV manual), you will see the following information displayed on your TV screen:

Your TV screen during Auto Setup if SCART is used

Turn on the TV

			i
		ENTER
– –:– –
		PR
			3
		PR
	AUDIO	– –:– –
			3
	VPS/PDC
	0000
			5
	?	30 SEC
	PR
PR	3
	PR
	i
		2	4
	ENTER
	LP00000-000
	VCR/TV

SELECT THE VIDEO CHANNEL

When Auto Setup has finished, you will see the following display panel on your VCR:

rf cable only If you have only used the RF	S-VHS	VCR
Cable to connect the VCR to the TV, you will
see this display. The number is the channel on
the TV that the Auto Setup has chosen to be the
video channel. In the example, we have

presumed that channel 52 is vacant and have set the VCR to 52:

Now tune the TV set to channel 52 (refer to TV manual if necessary); you should see two vertical white bars appear on the TV screen. If the bars do not appear or are not clear, choose another vacant channel pressing PR +/--on the Remote Control and try again. If you cannot obtain the vertical white bars on any channel between 22 and 69, consult your local JVC dealer.

rf and scart connection If you have chosen	S-VHS	VCR
to connect the VCR to the TV with both the RF
Cable and a 21-pin SCART Cable (not provided),
you need to press the PR --on the Remote

Control until the figure reads ‘– –’. This is because you will use the TV in AV mode to view video pictures and therefore do not need a dedicated video channel.

FINISH AUTO SETUP

Press and move on to Step 2 to check the results.

oops! If there is a power cut or you accidentally press a button during Auto Setup, turn the VCR off and then on again. Re-perform Auto Setup.