JVC HR-J256EK, HR-J455EK, HR-J255ES, HR-J255EK setup guide View Confirmation Screen

1 2 3

2

4 5 6

7 8 9

0 4

1 ?

MENU

31

		VIEW CONFIRMATION
4		SCREEN
		After "SCAN COMPLETED"	PR	CH	ID	PR CH	ID
		is displayed on the screen
			01	26	BBC1	07	– – – –
		for about 5 seconds, a	02	33	BBC2	08	– – – –
			03	23	ITV	09	– – – –
		Confirmation screen	04	30	CH4	10	– – – –
		looking like the one on the	05	37	CH5	11	– – – –
		right appears. The stations	06		– – – –	12	– – – –
		your recorder located	[5°]
		appear on a Confirmation	=		: EDIT
		screen — preset positions	= [X] : DELETE
			[MENU] : EXIT
		(PR), channels (CH) and
		station names (ID – ☞ pg. 35). The blueback screen
		and the programme currently being broadcast by the
		station which is blinking appear alternately for 8
		seconds each.
		To view the next page, use the %Þbutton on the
	remote control.
		● The Guide Program numbers will also be set
		automatically during Auto channel Set.
		RETURN TO NORMAL
5		SCREEN
		Press MENU.
		● Using the Confirmation screen, you can skip or add
		preset positions, enter station names and perform
		other operations. Refer to pages 32 – 34 for the
		procedures.
		● Depending on reception conditions, the stations may,
		on occasion, not be stored in order, and the station
		names may not be stored correctly.

IMPORTANT

●In certain reception conditions, station names may not be stored correctly, and auto Guide Program Number Set may not work properly. If the Guide Program numbers are not set properly, when you timer-record a TV programme using Video Plus+, the recorder will record a TV programme of a different station. When programming the timer using Video Plus+, be sure to check that the preset position correspond- ing to the broadcasting station you wish to record has been selected (☞ pg. 14, "Video Plus+ Timer Programming").

●Your video recorder memorizes all detected stations even if reception of some of them is poor. In these cases picture quality may be poor. To delete those stations which have an unacceptable picture ☞ "Delete A Channel" on page 33.

NOTES:

●Fine tuning is performed automatically during Auto Channel Set. If you wish to perform it manually, refer to page 33.

●If, for any reason, you perform Auto Channel Set when the aerial cable is not connected properly, "SCAN COMPLETED - NO SIGNAL-" appears on the screen in step 4. When this happens, make sure of the aerial connection and press OK; Auto Channel Set will take place again.