Disengage timer, Access Program screen | JVC HR-J4008UM specification

PRESS (+/–, SP/EP, 8=DAILY 9=WEEKLY), THEN (0K) PRESS (PROG.) TO END

– – – SP

DATE

– –/––/– –

– –:––AM

STOP

START

PROGRAM 1

– Timer Recording –

APress PROG on the Remote to access the Program screen.

B Press START+/–,STOP+/–,DATE+/– or PR+/– repeatedly to enter the start

time, stop time, date or channel.

● Press and hold START+/– or STOP+/– to increase the time in

30-minute intervals.

● To set the tape speed, press SP/EP (p).

● To timer-record daily (Monday–Friday) or weekly serials,

Checking, canceling or changing program settings

ADisengage timer

Press #, then press 1.

●When “AUTO TIMER” is set to “ON”, you do not have to press

press DAILY or WEEKLY. Pressing the button again makes the “DAILY” or “WEEKLY” display disappear.

CPress OK or PROG.

●If “PROGRAM NOT COMPLETED PROGRAM OVERLAP” appears, see “Program overlap warning display”.

DPress #. The VCR turns off automatically and “#” is displayed on the display panel.

To use the VCR while it is in timer recording standby mode

BAccess Program Check screen

Press " (CHECK).

CAccess Program screen

Press " (CHECK) again. Each time you press " (CHECK), the next program’s Program screen appears.

PR START		STOP	CH	DATE
1	8:00P	10:00	12	12/24
2	10:00A	10:45	40	12/25
3	11:30P	1:00	125	12/25
4
5
6
7
8
	PRESS (CHECK) TO NEXT
	PROGRAM 1
	START		STOP
	8:00 PM		10:00 PM
	DATE		CH
	12/24/00		12	SP

PRESS (CANCEL) TO CANCEL PRESS (CHECK) TO NEXT

Press #, then press 1. After you use the VCR, press # again to put the VCR into timer recording standby mode.

DCancel or change program setting

To cancel a program, press & (CANCEL) when the Program screen you do not want is shown.

To change a program, press the appropriate button: START+/–, STOP+/–, DATE+/–, PR+/–, and/or SP/EP (p) when the Program screen on which you want to make changes is shown.

EReturn to normal screen

Press " (CHECK) repeatedly until no Program screen is shown.

FReengage timer recording standby mode

Press #. The VCR turns off automatically and “#” is displayed on the display panel.

●When “AUTO TIMER” is set to “ON”, the timer recording standby mode automatically resumes when you turn off the VCR.