JVC HR-J4008UM manual Other Functions, Checking tape position, Select program to modify

PR START STOP CH DATE

1 8:00P 10:00 12 12/24

2 10:00A 10:45 40 12/25

3 11:30P 1:00 125 12/25

4 9:00P 10:00 10 12/24

5

6

7

8

( , ), THEN ( ) (PROG.) : END

– Timer Recording –

Program overlap warning display

If “PROGRAM NOT COMPLETED PROGRAM OVERLAP” appears, you have another program overlapping the program you have just made. The Program Check screen appears and conflicting programs will start blinking.

	PR START		STOP	CH	DATE
PROGRAM NOT COMPLETED	1	8:00P	10:00	12	12/24
	2	10:00A	10:45	40	12/25
PROGRAM OVERLAP	3	11:30P	1:00	125	12/25
	4	9:00P	10:00	10	12/24
	5
	6
	7
	8
	(	, ), THEN ( ) (PROG.) : END

Example:

Program 1 (you have just made) and Program 4 overlap each other

A Select program to modify

Press rt, then press e.

● You can only select one of the overlapping programs.

● If you do not mind this overlap, press

PROG to finish the timer program setting. The program starting earlier or

program with the lower program number will be recorded.

B Cancel or change program setting		PROGRAM 4
To cancel a program, press & (CANCEL)	START	STOP
when the Program screen you do not want	9:00PM	10:00PM
	DATE	CH
is shown.	12/24/00	10 SP
	SUN

Other Functions

Checking tape position

When you change the VCR operation
mode from the stop mode to fast forward
or rewind mode, or when you perform an
Index Search or Instant Review, the tape	B	+ +	+	E
position indicator appears.
The position of “q” in relation to “B”
(Beginning) or “E” (End) shows you where
you are on the tape.

●Set “SUPERIMPOSE” to “ON”.

Changing display information

Each time you press – –:––, the display panel shows the channel number and the clock time alternatively.

● You can change display in the stop, recording or recording pause mode, or during rewind/fast- forward high-speed search.

●When “SUPERIMPOSE” is set to “ON” and – –:– – on the Remote is pressed, time counter will appear on the TV screen. To reset the time counter, press 0000 on the Remote.

To change a program, press the	PRESS (CANCEL) TO CANCEL
appropriate button: START+/–, STOP+/–,	PRESS (OK) TO CONFIRM
	PRESS (PROG.) TO END

DATE+/–,PR+/–, and/or SP/EP (p)

when the Program screen on which you want to make changes is shown, then press OK.

●If the overlap is not yet solved, the conflicting programs will be shown on the Program check screen. Repeat the above steps again.

Timer warning display

A warning appears on the TV screen to tell you that the timer-recording is to start in 5 minutes if you are not in the timer recording standby mode at that time. Press

#to put the VCR into timer recording

standby mode. To clear the display, press & (CANCEL) on the Remote.

–WARNING–

TIMER RECORDING TO START SOON

(CANCEL)