JVC SR-9080 This unit should be used with 120 V AC only, For Your Safety Australia, Power System

Page 2

SAFETY PRECAUTIONS : U model

E model SAFETY PRECAUTIONS

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INDIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

This unit should be used with 120 V AC only.

CAUTION: To prevent electric shocks and fire hazards, do NOT use any other power source.

NOTE: The rating plate (serial number plate) is on the rear of the unit.

INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installa- tion. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television recep- tion, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

CAUTION CHANGES OR MODIFICATIONS NOT APPROVED BY JVC COULD VOID USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERA- TION.

ATTENTION

RISQUE D’ELECTROCUTION

NE PAS OUVRIR

ATTENTION: POUR EVITER TOUT RISQUE D’ELECTROCUTION NE PAS OUVRIR LE BOITER. AUCUNE PIECE INTERIEURE N’EST A REGLER PAR L’UTILISATEUR. SE REFERER A UN AGENT QUALIFIE EN CAS DE PROBLEME.

Le symbole de l’éclair à l’intérieur d’un triangle équilatéral est destiné à alerter l’utilisateur sur la présence d’une “tension dangereuse” non isolée dans le boîtier du produit. Cette tension est suffisante pour provoquer l’électrocution de personnes.

Le point d’exclamation à l’intérieur d’un triangle équilatéral est destiné à alerter l’utilisateur sur la présence d’opérations d’entretien importantes au sujet desquelles des renseignements se trouvent dans le manuel d’instructions.

*Ces symboles ne sont utilisés qu’aux Etats-Unis.

AVERTISSEMENT: POUR EVITER LES RISQUES D’INCENDIE OU D’ELECTROCUTION, NE PAS EXPOSER L’APPAREIL A L’HUMIDITE OU A LA PLUIE.

Ce magnétoscope ne doit être utilisé que sur du courant alternatif en 120 V.

ATTENTION: Afin d’éviter tout resque d’incendie ou d’électrocution, ne pas utiliser d’autres sources d’alimentation électrique.

REMARQUE: La plaque d’identification (numéro de série) se trouve sur le panneau arrière de l’appareil.

WARNING: The battery used in the SR-9080U must be replaced by a JVC authorized service dealer only.

This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus as set out in the interference-causing equipment standard entitled “Digital Apparatus”, ICES-003 of the Department of Communications.

Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils numériques de Classe B prescrites dans la norme sur le matériel brouilleur: “Appareils Numériques”, NMB-003 édictée par le ministre des Communications.

Warning Notice

FOR YOUR SAFETY (Australia)

1.Insert this plug only into effectively earthed three- pin power outlet.

2.If any doubt exists regarding the earthing, consult a qualified electrician.

3.Extension cord, if used, must be three-core correctly wired.

IMPORTANT

Connection to the mains supply in the United Kingdom. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain a proper safety approved extension lead/adapter or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted, and to replace the fuse cover. If nonetheless the mains plug is cut off remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. If this product is not supplied fitted with a mains plug then follow the instructions given below: DO NOT make any connection to the Larger Terminal coded E or Green. The wires in the mains lead are coloured in accordance with the following code:

Blue to N (Neutral) or Black

Brown to L (Live) or Red

If these colours do not correspond with the terminal identifications of your plug, connect as follows: Blue wire to terminal coded N (Neutral) or coloured Black. Brown wire to terminal coded L (Live) or coloured Red. If in doubt — consult a competent electrician.

CAUTION

When you are not using the recorder for a long period of time, it is recommended that you disconnect the power cord from the mains outlet.

Dangerous voltage inside. Refer internal servicing to qualified service personnel. To prevent electric shock or fire hazard, remove the power cord from the mains outlet prior to connecting or disconnecting any signal lead or aerial.

POWER SYSTEM

Connection to the mains supply

This unit operates on voltages of 220 to 240 V AC, 50/ 60 Hz.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

To prevent electric shock, do not open the cabinet. No user serviceable parts inside. Refer servicing to qualified service personnel.

Note:

The rating plate and the safety caution are on the rear of the unit.

The OPERATE button does not completely shut off mains power from the unit, but switches operating current on and off.

Notes on the built-in lithium battery

WARNING: THE UNIT CONTAINS A BUILT-IN LITHIUM BATTERY FOR MEMORY BACK-UP THAT MUST ONLY BE REPLACED BY SUITABLY QUALIFIED SERVICE PERSONNEL. FOR BATTERY REPLACEMENT, TAKE THE UNIT TO YOUR DEALER OR A JVC SERVICE STATION.

(Danish)

ADVARSELI Lithiumbatteri — Eksplosionsfare. Udskiftning ma kun foretages al en sagkynding. og som beskrevet i servicemanualen.

This unit is produced to comply with Directives 76/889/ EEC, 82/499/EEC, 87/308/EEC and Standard IEC Publ. 65.

CAUTION

To prevent electric shock and to avoid damaging the unit, first insert the smaller plug on the AC power cord into the VCR, making sure that it is securely connected, and then plug the larger end of the AC power cord into an AC outlet.

COPYRIGHT © 1999 VICTOR COMPANY OF JAPAN, LIMITED Printed in Japan

2 (U)

2 (E)

Image 2
Contents Trouble Shooting Controlsand Connectors ConnectionsSwitches IntroductionThis unit should be used with 120 V AC only For Your Safety AustraliaPower System Connection to the mains supplyContents Introduction Major FeaturesPeriodical Maintenance IntroductionDaily Inspection Precautions Video cassetteFront Panel REC16 17 18 Model Display Controls and Connectors Rear PanelConnections Connecting to a CameraSystem Using Sequential Switcher ConnectionsOn-Screen Display Connecting the Rear Panel Input/Output Terminal ConnectionsModel Selecting the data display Contents of the main menu items ON-SCREEN/MENU SwitchesON-SCREEN/MENU Switches Main Menu Display1During daylight savings time Date and Time SettingHour Meter Display 1Standard timeAlarm Input/Power Loss Data Display Menu Switch SettingContents of Menu Switches IN/OUT SensorBuzzer Preparation Recording/Playback Speed Mode SelectionCassette Loading/Unloading Auto operate on Auto playALARM/SENSOR Mode Recording/Playback Speed Mode SelectionSwitch Setting During Recording RecordingRecording Timer Recording Program SettingReset Recording Basic OperationTimer Program No Timer button Menu button SET + button SET buttonOFF Operation is disabled ST 1st week RPT Every week Stop time Start time Day of the week1ST Timer RecordingTimer Recording Timer Program Timer screenStop time Start time On Enabled Day of the week Day of the week RPT Every weekHoliday Timer Recording Setting Menu button SET button SET + buttonStandby mode is engaged Canceling/Changing Timer Recording1To modify timer programs ProgramAlarm Recording Sensor Recording Series RecordingRepeat Recording Non-stop continuous series recordingExternal Timer Recording Recording with External VCR Activation SignalHow to Restore Recording After Power Failure Tape End Buzzer5To stop playback PreparationPlayback Special-Effects Playback Playback and SPECIAL-EFFECTS PlaybackSpecial-Effects Playback Alarm search Alarm Search/Date and Time SearchAlarm scan Date/time searchV. Pulse Tracking/V Lock AdjustmentRepeat Playback Counter Memory FunctionDisplay section Error indication Buzzer screen TroubleshootingError Indication Contents VCR operation MeasuresInstallation of the SA-K97U Optional SA-K97U RS-232C Interface BoardOptional SA-K97U RS-232C Interface Board SA-K97U SpecificationsSA-K97U RS-232C Protocol & Commands RXD SA-K97U RS-232C Protocol & CommandsTXD Count Reset E2H Cancel 67HAL/PL Reset E1H Date SET 8EH1st/2nd byte Commands for VCR status verificationContents of 5th byte BIT 0/1/2/3 Speed Code 3rd byte 5th byteCommands reference chart HDR OFF AppendixesTape Reel Counter/Tape Remaining Time Table HDR onRear Panel’s Input/Output SpecificationsAppendixes