JVC LPT0641-001A manual 82 EN

Page 82

82 EN

SPECIFICATIONS

GENERAL

Power requirement : AC 120 Vd, 60 Hz

Power consumption

Power on

: 35 W

Power off

: 4.4 W

Temperature

 

Operating

: 5°C to 40°C (41°F to 104°F)

Storage

: –20°C to 60°C (–4°F to140°F)

Operating position : Horizontal only

Dimensions (WxHxD)

 

: 435 mm x 106 mm x 380 mm

 

(17-³/16” x 4-³/16” x 15”)

Weight

: 5.1 kg

 

(11.2 lbs)

Input/Output

: RCA connectors:

 

IN x 2, OUT x 2

 

S-Video connectors:

 

IN x 2, OUT x 2

 

DV connector:

 

IN/OUT x 1 (4-pin, IEEE1394

 

conformity, digital input/output)

VHS DECK VIDEO/AUDIO

Signal system

: NTSC-type color signal and EIA

 

monochrome signal, 525 lines/

 

60 fields

Recording system

: DA4 (Double Azimuth) head helical

 

scan system

Format

: S-VHS/VHS NTSC standard

Signal-to-noise ratio: 45 dB

Horizontal resolution

:230 lines (VHS)

400 lines (S-VHS)

Frequency range

: 70

Hz to 10,000

Hz (Normal audio)

 

20

Hz to 20,000

Hz (Hi-Fi audio)

Maximum recording time

 

(SP)

: 210 min. with ST-210 video cassette

(EP)

: 630 min. with ST-210 video cassette

DV DECK VIDEO/AUDIO

Signal system

: NTSC-type colour signal, 525 lines

 

60 fields

Recording system

: Digital Component Recording

Format

: DV format (SD mode)

Cassette

: Mini DV Cassette

Maximum recording time

(SP)

: 80 min. with M-DV80ME cassette

(LP)

: 120 min. with M-DV80ME cassette

Audio recording system

:PCM 48 kHz, 16 bit (2 ch)/ 32 kHz, 12 bit (4 ch)

TUNER

Tuning system

: Frequency synthesized tuner

Channel coverage

 

VHF

: Channels 2–13

UHF

: Channels 14–69

CATV

: 113 Channels

TIMER

Clock reference

: Quartz

Program capacity

: 1-year programmable timer/

6 programs each on the VHS and DV deck

Memory backup time

: Approx. 10 min.

ACCESSORIES

Provided accessories

:RF cable (F-type), Audio/Video cable, S-Video cable (4-pin), Controller,

Infrared remote control unit, “AA” battery x 2

Specifications shown are for SP mode unless otherwise specified. E.& O.E. Design and specifications subject to change without notice.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.

Page 81 Page 83
Image 82
Page 81 Page 83
Contents Video Cassette Recorder For Customer UseDear Customer Moisture CondensationImportant Product Safety Instructions Damage Requiring Service AccessoriesCleaning Replacement PartsContents Front View Rear View Front Display Panel How To Use RemoteTo recall an indication 10 ENON-SCREEN Display for VHS deck Press DISPLAY/OSDON-SCREEN Display for DV deck 12 EN Check the contentsConnect the VCR to power source Situate the VCR8To connect to a TV with S-VIDEO/AUDIO input connectors Video ConnectionPlug & Play Set Perform Plug & Play setupWhat to do if Plug & Play setting failed 14 ENLanguage 16 EN Access the Clock Set screenClock Set PreparationsSemiauto Clock Set Manual Clock Set18 EN Access the Tuner Set screenTuner Set Auto Channel SetTo add channels Manual Channel SetAdd or skip the desired channels To skip channelsInstalling Controller 20 ENSelect the cable box’s channel Access the Cable Box Set screenTurn on the cable box If you do not use a cable box, press rt until OFFPress OK or e 22 ENEnter the cable box’s brand If the cable box’s channel does not change toHow to control the DBS receiver If your DBS receiver has audio/video output connectorsDBS receiver Select the DBS receiver’s channel Setting DBS receivers brand and channelTurn on the DBS receiver If you do not use a DBS receiver, press rt until OFFEnter the DBS receiver’s brand If the DBS receiver’s channel does not change as shown above26 EN Basic PlaybackVHS deck Start recording Choose a programSet the tape speed Pause/Resume recordingPause during playback 28 ENSlow Motion On the VCR Activate frame-by-frame playbackSlow Motion On the Remote Variable Speed Search On the RemoteRepeat Playback 30 ENIndex Search Next Function MemorySoundtrack Selection Adjust the tracking manuallyManual Tracking Override automatic tracking32 EN Instant Timer Recording ITRRecord One Program While Watching Another Tape Remaining Time Reset the counterPress C.RESET before starting recording or playback Set the counter displayRetake 34 ENSecond Audio Recording Playback Active Video CalibrationRecording Select the DV deck 36 ENDV deck Press DVDV recording indicator lights on the VCR 38 EN Slow Motion On the Remote 40 EN Time Code 42 EN Access the PlusCode No. screenAccess the VCR Plus+ Program screen Select the deckFor the DV deck Engage the VCR’s timer modeFor the VHS deck Cable Box or DBS Receiver UsersGuide Channel Number Set Access the Guide Channel Set screen44 EN Enter the Guide Channel numberGuide Channel Number Enter the receiving channel position numberExpress Timer Programing 46 ENPress DATE+ Enter the program dateEnter the channel position Press CH+48 EN Enter the program mode24HR Quick Programing Set the program start/stop time and channelPage Cancel or change a program Disengage the timer modeAccess the Program Check screen Return to the timer modeSelect the program to modify Cancel or change program settingConfirm the overlapping programs Overlapping programs blink on the TV screenFrom DV to VHS Tape Dubbing52 EN Dubbing An Entire CassetteFrom VHS to DV Press DV, then press SP/LP pPrepare the VHS deck for dubbing 54 ENLocate the start point on the DV deck Pause dubbingLocate the start point on the VHS deck Prepare the DV deck for dubbing56 EN Recorder PlayerStart the source player Set the input mode of recording deck58 EN Start the recording deckPC with DV connector Connection to a PC with DV connectorExample When using this VCR as the source player Connection to another VCRVHS Audio Dubbing Audio Dubbing60 EN DV Audio DubbingEnd Audio Dubbing Engage the Audio Dubbing modePress A.DUB VHS Insert Editing Insert Editing62 EN Source tapePrepare the recording cassette Engage the Insert Editing modeAV Insert Editing VHS deck only Start EditingSelect the program Access the R.A.Edit screen64 EN Press R.A.EDIT. The R.A.Edit screen appearsStart Random Assemble Editing Locate the end pointPrepare the source tape End Random Assemble EditingChange the code for VCR Remote A/B Code Switching66 EN To control two VCRs with the same RemoteOperate the TV TV Multi-Brand Remote ControlSet the TV brand code Before performing the following stepsSet the Cable Box brand code Press the corresponding button Power68 EN Operate the Cable BoxSet the DBS receiver brand code DBS Receiver Multi-Brand Remote ControlOperate the DBS receiver Select the mode Mode SetAccess the Mode Set screen Select the mode settingMode SET When this function is set to onVHS Mode SET 72 ENVHS Mode SET 74 EN For ExampleNormally select this. Hi-Fi sound is played back Correction to the luminance signal to enhance detailsSelecting either HI-FI L or HI-FI R Sound on the left Hi-Fi channel is played backDV Mode SET 76 ENPower 78 EN RecordingVHS deck DV deckTimer Recording 80 ENPlayback Timer RecordingRecording 82 EN Express Timer Programming Cable box Cable Box Control SettingChanging VCR Plus+ Setting VCR Plus+ Timer ProgramingHOW to Locate Your JVC Service Center 84 ENWarranty Only in U.S.A 86 EN
Top Page Image Contents