JVC HR-J239EE manual Tune The TV To Your Video Recorder, Select Televi- sion System

4EN

INSTALLINGYOURNEWRECORDER (cont.)

Tune The TV

To Your Video

Recorder

2 2

q 5/8

OPERATE

Back of VCR

TEST G	K
	RF

The video recorder sends picture and sound signals via the RF connecting cable to your TV on UHF channel 36.

1		TURN ON THE RECORDER
		Press OPERATE.
2		SELECT OUTPUT MODE
		Set the TEST/System switch on the back of the recorder
	to TEST.
3		SET TV CHANNEL
		Set your TV to the video channel (UHF channel 36).
		Two white bars appear on screen vertically.
		● Tune the TV until the bars are as clear as they can be.
		● Your TV should be set to the channel designated for
		use with a video recorder, or to a spare channel if
		there is not a specified video channel on your TV.
		● The audio signal may not be heard or may be noisy;
		this is not due to any defect of the unit.
4		RESET OUTPUT MODE
		Set the TEST/System switch to the appropriate position
	(G or K). Refer to the chart in "Select Television System"
	below.

NOTES:

●If CH36 is occupied by a local station, adjust the RF output channel adjustment screw to use another channel between CH32 and CH40 instead.

●If some interference noise is continually seen on the screen, consult your JVC dealer.

Select Televi- sion System

Major countries	Colour TV broadcast	Switch
	system	position
China, Mongolia,	PAL D/K
Rumania
		K
Bulgaria, Czech Rep.,
Slovakia, Hungary,	SECAM D/K
Poland, Russia
Austria, Denmark,
Finland,Holland, Italy,
Norway, Spain,	PAL B/G	G
Switzerland, Sweden,
Germany
Egypt	SECAM B/G

SET TEST/SYSTEM SWITCH

1 Set to the appropriate position depending on your TV system. (Refer to the chart on the left.)

NOTES:

●If no colours appear on the screen when using a multi-system television with its system select switch set to AUTO, change the switch position to correspond to the recorder's RF system select switch (G or K).

●For more information on multi-system compatibility. ☞ p.22