JVC HR-DVS3EU specifications Engage the Audio Dubbing mode, End Audio Dubbing, Press A.DUB

EN 55

A Make connections.

Connect an audio component to the AUDIO L + R input connectors on the recorder’s front panel.

●When connecting a monaural audio component, use only the recorder’s AUDIO L input connector.

B Load a cassette.

For the VHS deck

Insert a VHS (or S-VHS) cassette with the record safety tab intact, or cover the hole using adhesive tape.

For the DV deck

Insert a Mini DV cassette with the erase protection switch set to “REC”.

C Select the recording deck.

Press VHS or DV.

●When using the DV deck as the recording deck, press so that the audio signals from the AUDIO L + R input connectors can be recorded. The dubbing direction indicator ( VHS) lights.

D Set the recorder’s input mode.

Press AUX (number key “0”) and/or PR to select “F-1”.

E Locate the start point.

Press 4 to start playback of the tape in your recorder, and press 9 when you reach the point where you want to start dubbing.

F Engage the Audio Dubbing mode.

Press A.DUB.

●Your recorder enters the Audio Dubbing Pause mode. (“o” blinks, “u” and “i” light up on the front display panel.)

●To perform Audio Dubbing with audio mixing, press AUDIO to select “HI FI L jhR” or “L jhR” at this point. When

using the DV deck as the recording deck, also make sure that “12BIT MODE” is set to “SOUND1” ( pg. 73).

*Audio Dubbing with audio mixing is not possible if you are using a monaural audio component, or if you don’t have an audio mixer.

G Start dubbing.

Engage the audio component’s Play mode, then press 4 to start the tape in your recorder; Audio Dubbing begins at this point.

●“o” blinks and “u” is displayed on the front display panel.

●To stop dubbing temporarily, press 9. Press 4 to resume dubbing.

H End Audio Dubbing.

Press 8 to stop the tape in your recorder, and engage the audio component’s Stop mode.

NOTES:

●Once the Audio Dubbing starts, you can not use the other deck.

●When monitoring the audio-dubbed sound on the DV deck, set “12BIT MODE” to “SOUND2” ( pg. 73).

●When monitoring the sound during Audio Dubbing, the normal soundtrack is automatically selected. If you wish to

hear the mixed sound (Hi-Fi + Normal soundtracks), press AUDIO to select “HI FI NORM” ( pg. 25). (VHS deck only)

●Audio Dubbing stops automatically when the counter reaches “0:00:00”, and the recorder enters the Play mode. Check the counter reading before dubbing. (VHS deck only)

●Audio Dubbing is also possible using the rear panel AV1 (L-1) IN/OUT or AV2 (L-2) IN/DECODER connector. When using these 21-pin SCART connectors, be sure to select the correct input mode (“L-1” or “L-2”) in step 4.

●When playing back an audio-dubbed tape on the VHS deck,

press AUDIO on the remote control to select the soundtrack you wish to hear ( pg. 25). When playing back an audio-

dubbed Mini DV tape on the DV deck, set “12BIT MODE” to “SOUND2” ( pg. 73).

●Audio dubbing is not possible using the DV IN/OUT connector.

●Audio dubbing is not possible on a blank portion of the tape.