JVC HR-DD845EK setup guide Video Channel Set, With RF Connection

6INITIALSETTINGS

Video Channel Set

Video Channel (RF Output Channel) is the channel on which your TV receives picture and sound signals from the video recorder through the RF cable.

If you have connected the video recorder to your TV via the provided RF cable only (RF connection) – Go to "With RF Connection" below.

If you have connected the video recorder to your TV via both the provided RF cable and a 21-pin SCART cable (AV connection) – Go to "With AV Connection" on next page.

IMPORTANT:

Before performing the following steps, make sure the recorder's power is off and there is no cassette inserted in the recorder.

4 With RF Connection

	ACCESS VIDEO CHANNEL SET MODE
	Press and hold down STOP on the recorder until the
q	1 display panel shows the following.

2	PROG+/–TV				STOP	1	SET VIDEO CHANNEL
							2 ● If the two vertical white bars appear clearly on the
							Set your TV to UHF channel 52. (Refer to the instructions
							supplied with your TV set for how to do this.)
							screen as shown in the illustration at bottom left, go
					4		to step 3.
							● If the two vertical white bars do not appear clearly, press
							TV PROG+ or – to set the video recorder to a vacant
							channel between 22 and 69 which is not occupied by
		2					any local station in your area. Refer to list on page 47
	1	2	3				for details of broadcast stations in your area.
							(Ex.) If channel 36 is available in your area
	4	5	6
	7	8	9
		0	4				Then set your TV to UHF channel 36 and check if the
						2	two vertical white bars appear clearly on the screen; if
				TV PROG			so, go to step 3. If not, re-set the video recorder to
							another vacant channel and try again.
							NOTES:
							● If you set the video recorder to a channel which is
							occupied by a local station or has neighbouring
							channels that are occupied by local stations, the
							picture reception quality will be affected and some
							interference noise will appear on the TV screen. Be
					3		sure to select a vacant channel which has no
			3	OK			broadcast on neighbouring channels.
	1						● If you cannot obtain the two vertical white bars
							clearly with any channel between 22 and 69, consult
							your JVC dealer.
TEST SIGNAL							EXIT VIDEO CHANNEL SET MODE
							3 Press OK.
	The channel on which the screen to
	the left appear clearly in step 2 is						TURN OFF THE RECORDER
	your Video Channel.
							4 Press	.

To view picture signals from the video recorder, set your TV to the Video Channel.

After you finish this step, go to "Auto Set Up" on page 8.