STOP
41
With RF Connection
Before performing the following procedure, make sure that:
■the mains power cord is plugged into the mains outlet.
■ the video recorder is turned off and there is no cassette inserted in the recorder.
■the connected TV is turned on.
■ batteries have been installed in the remote control.
–
ACCESS VIDEO CHANNEL SET MODE
1 Press and hold down STOP on the recorder until the display panel shows the following.
SET VIDEO CHANNEL
1 2 3
4 5 6
7 8 9
0
1
2
4
TV PROG
OK
2 Press TV PROG+ or – to set the video recorder to a vacant channel between 22 and 69 which is not occupied by any local station in your area. Refer to list on page 48 for details of broadcast stations in your area.
(Ex.) If channel 36 is available in your area
Then set your TV to UHF channel 36. (Refer to the instructions supplied with your TV set for how to do this.)
●If the two vertical white bars appear clearly on the screen as shown in the illustration at buttom left, go to step 3.
●If the two vertical white bars do not appear clearly, re- set the video recorder to another vacant channel and try again.
IMPORTANT
●If you set the video recorder to a channel which is occupied by a local station or has neighbouring channels that are occupied by local stations, the picture reception quality will be affected and some interference noise will appear on the TV screen. Be sure to select a vacant channel which has no broadcast on neighbouring channels.
●If you cannot obtain the two vertical white bars clearly with any channel between 22 and 69, consult your JVC dealer.
EXIT VIDEO CHANNEL SET MODE
TEST SIGNAL
The channel on which the screen on the left appears clearly in step 2 is your Video Channel.
3 Press OK.
To view picture signals from the video recorder, set your TV to the Video Channel.