JVC HR-DD445EK setup guide If your recorder receives, Press OK after entering

6

TIMER

q

Á 1

		ADD TIME
	1	2	3
NUMBER	4	5	6
	7/	8	9		WEEKLY
DAILY
		0		4	TIMER 6
4
	2
	1	3			Á
	¦	7		8
	1	4			¢

MENU

3

5 OK

Satellite Receiver Users

To timer-record a satellite broadcast using Video Plus+, perform steps 1 – 6 and, before the selected programme begins, select the appropriate channel on the satellite receiver. Then set the receiver's timer. If your satellite receiver doesn't have a timer, leave the unit's power switched on.

		23
4	SET TAPE SPEED
	Press SP/LP ( ) to set the tape speed.
5	RETURN TO NORMAL SCREEN
	Press OK.
	● Repeat steps 1 – 5 for each additional programme.
6	ENGAGE RECORDER’S TIMER MODE
	Press TIMER. The recorder turns off automatically.

NOTE:

To Delay The Stop Time . . .

. . . press ADD TIME after pressing OK in step 3. Each time you press, the Stop time is delayed by 5 minutes (meaning that 5 minutes of recording time is added). You can easily compensate for anticipated programme schedule delays this way.

To Timer-Record Weekly Or Daily Serials . . .

. . . after pressing OK in step 3, press WEEKLY (NUMBER key “9”) for weekly serials or DAILY (NUMBER key “8”) for daily serials (Monday – Friday). Either "WEEKLY" or "DAILY" appears on the screen. Pressing the button again makes the correspond- ing indication disappear.

You can programme this recorder to timer-record as many as 8 programmes. If you try to programme the recorder to record a ninth, "PROGRAM FULL" appears on screen and "FULL" appears on the front display panel. To record the extra programme, you must first cancel any unnecessary programmes (☞ pg. 26).

ATTENTION

Regarding Guide Program Number Set

"ERROR=GUIDE PROG" appears after performing step 3 on the previous page if the Guide Program number for the PlusCode number you entered has not been set.

●If the recorder is in the stop or rewind or fast-forward mode, the following screen will appear with "– –" under "TV PROG" flashing.

•Press the NUMBER keys or PUSH JOG %Þto input the preset position number your recorder receives that station on, then press OK.

GUIDE PROG SET

			(Ex.) To timer-record a BBC2
GUIDE PROG		TV PROG	programme with Video Plus+
			* If your recorder receives
	2	– –	BBC2 on the preset position
			2, press OK after entering
			"2".
[5°] =
[MENU] : EXIT

• Press MENU, then try again from step 1.

●If the recorder is in a mode other than the above mentioned modes, press MENU first and input the correct Guide Program number for that PlusCode number (☞ pg. 10, "Video Plus+ Setup"), then try again from step 1.