4.1 Searching broadcasting services 31
1.Choose your desired satellite at the Satellite Name op- tion.
2.Select the tuner that is connected to the motorized an- tenna at the Tuner Select option.
3.Set the DiSEqC Command Mode to User.
4.Select the Goto option at the Motor Control menu. Then the antenna will turn toward your selected satellite with the position data that the digital receiver has.
5.If the receiving quality, which is displayed on the right bottom on the screen, is not good, tune the antenna finely with the options of the Movement menu. If you select the 2(E) movement option, the antenna will move to the east by two degrees. At this time you had better check the receiving quality of every transponder and choose the best one at the Transponder (or Frequency) option. It will be helpful to your fine tuning.
6.Finally select the Store option at the Motor Control menu to save the tuned position when the receiving quality has turned good.
There are more motor control options for installers, but this manual does not describe them. If you are an installer, refer them to the manual for the STAB rotor.
4.1.3 Configuring USALS settings
USALS (Universal Satellite Automatic Location System), also known as DiSEqC 1.3, calculates the positions of all available satellites from your location. Compared to DiSEqC 1.2, it is no longer required to manually search and store every satel- lite position. Just by pointing to a known satellite position is enough. This position will act as the central point. The USALS will then calculate positions of visible satellites.