12 Setup
ceiver to your television antenna so that it can receive digital television services.
Connect the antenna cable to the LNB 1 IN socket on the back panel of the digital re- ceiver.
However your digital receiver is connected to the television, you must ensure that there is a connection to both the LNB 1 IN and LNB 2 IN connectors on your digital receiver, so that both tuners work properly.
Normally you do that by using a loop cable to link from the IF 1 OUT connector to the LNB 2 IN connector.
If you have two antennas without DiSEqC switch, then you have to connect a cable from the other antenna directly to the LNB 2 IN connector rather than using the loop cable.
If you have another digital receiver, link it from the IF 2 OUT connector.
NOTE
The digital receiver can supply a current of 500 milliampere at maximum for antenna devices including LNB, DiSEqc switch and antenna rotor through each antenna input connection sep- arately but not simultaneously. So if there are too many an- tenna devices to be supplied with power through antenna in- put connections simultaneously for a long time, your LNBs may lack power to operate. So it is recommended to link the IF 1 OUT connector to the LNB 2 IN connector with a loop cable even though the digital receiver is designed to operate over two antennas alternatively.
2.4.2 Connecting to your television
Between all the following connectors of your digital receiver, we recommend you use the first connector to get best picture