Sherwood VD-4500 manual Basic Playback, Starting Playback, To stop playback, To remove the disc

Basic Playback

Before playing

•Turn on the TV and set the TV to the DVD Player’s input.

•Turn on the audio system and set it to the DVD Player’s input, if an audio system is connected to the DVD Player.

•DVD-Video, Video CD, CD, MP3, WMA, JPEG can be played with the DVD Player (see “Notes on Discs” on page 6 and 8). Do not play anything else.

About the marks in the pages related to disc operation

means the function or title is related to DVD-Video operation.

means the function or title is related to Video CD operation.

means the function or title is related to audio CD operation. means the function or title is related to MP3/WMA sound operation. Both MP3 and WMA are referred to as MP3 in the following pages.

means the function or title is related to JPEG image operation.

Warning

If the DVD Player is connected to the TV or amplifier through the analog audio jacks, do not play DTS-encoded discs. Excessive noise may be output from the analog stereo jacks, which may damage the connected equipment. To reproduce DTS surround sounds, digital connection to an amplifier with a DTS decoder is needed.

Starting Playback

1 Press Open/Close		.			■ To stop playback
The disc tray opens. If the DVD Player is in standby					Press Stop ■ .
mode when the Open/Close				button is pressed, the	When you press Play/Pause			to restart playback,
DVD Player turns on and the disc tray opens. In this					playback starts from the location where you stopped
case, it takes several seconds until the disc tray					playback because the location index is stored in memory.
opens.					For MP3/WMA/JPEG playback, see page 19.
					Notes
2 Place a disc on the disc tray.
					• The location where playback resumes may vary
Put the disc in the tray with the label side facing up.
					depending on the disc or the scene where you stopped.
There are two different disc sizes. Place the disc in the
					• Press Stop ■ again after stopping playback to clear
correct guide on the disc tray.
					the location index memory, then press Play/Pause
3 Press Play/Pause			.
						to start playback.
The disc tray closes and playback starts. The					■ To remove the disc
appropriate disc indicator lights.
The disc indicator does not light up for CDs that					Press Open/Close		to open the disc tray.
contain JPEG images. For the other information that					Remove the disc after the disc tray opens completely.
appears in the display, see page 10.					After removing the disc, be sure to press the button again
If the DVD Player is in standby mode when					to close the tray.
Play/Pause	is pressed, the DVD Player turns on				CAUTION
and playback starts. In this case, it takes several
					Keep your fingers well clear of the disc tray as it is
seconds until playback starts.
					closing. Neglecting to do so may cause serious personal
Tip to obtain a higher quality picture
					injury.

Occasionally, some picture noise not usually visible during a normal broadcast may appear on the TV screen while playing a DVD-Video because the high resolution pictures on these discs include a lot of information. While the amount of noise depends on the TV you use, you should generally adjust the TV to reduce sharpness when viewing DVD-Videos.

17