Sherwood VD-4500 manual Precautions, Australia

Precautions

FOR YOUR SAFETY

		Units shipped to the U.S.A and Canada are designed for operation on 120V AC
		only.
		Safety precaution with use of a polarized AC plug.
U.S.A	120V	However, some products may be supplied with a nonpolarized plug.
and		CAUTION : To prevent electric shock, match wide blade of plug to wide slot,
CANADA
		fully insert.
		ATTENTION : Pour éviter chocs électriques, introduire la lame la plus large de
		la fiche dans la borne correspondante de la prise et pousser
		jusqu’ au fond.
		The available power supply voltage differs according to country or region.
		However, this unit is equipped with an Automatic Voltage Selector.
		The power supply voltage of the area where the unit will be used automatically
CHINA,		meets the required voltage within the range of AC 100 - 240 V, without any
		manual voltage adjustment.
EUROPE,	220V
		To ensure safe operation, the three-pin plug supplied must be inserted only into a
AUSTRALIA
	~	standard three-pin power point which is effectively earthed through the normal
and
	240V	household wiring. Extension cords used with the equipment must be three-core
other
		and be correctly wired to provide connection to earth.
countries		Improper extension cords are a major cause of fatalities. The fact that the
		equipment operates satisfactorily does not imply that the power point is earthed
		and that the installation is completely safe. For your safety, if in any doubt about
		the effective earthing of the power point, consult a qualified electrician.

PRECAUTIONS

■Moisture condensation

Moisture may form on the lens in the following conditions.

•Immediately after a heater has been turned on.

•In a steamy or very humid room.

•When this unit is moved from a cold place to a warm one.

If moisture forms inside this unit, it may not operate properly.

In this case, turn on the power and wait about one hour for the moisture to evaporate.

■If there is noise interference on the TV while a broadcast is being received.

Depending on the reception condition of the TV, interference may appear on the TV screen while

you are watching a TV broadcast and this unit is left on. This is not a malfunction of this unit or the TV. To watch a TV broadcast, turn off this unit.

■Do not transport this unit with discs left in it.

■Do not place on the component such as amplifier or receiver that generates heat. If so, the temperature inside this unit rises and malfunction may occur.

4