Meridian Audio DVP1500 manual Do not allow any unqualified person to install the unit

Page 4

SAFETY PRECAUTIONS

This product should be operated only with the type of power source indicated on the label. If you are not sure of the type of power supply to your home, consult your product dealer or local power company.

This product is equipped with a three-wire plug. This plug will fit only into a grounded power outlet. If you are unable to insert the plug into the outlet, contact your electrician to install the proper outlet. Do not defeat the safety purpose of the grounded plug.

Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them. Pay particular attention to cords at doors, plugs, receptacles, and the point where they exit from the product.

For added protection of this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the cable system. This will prevent damage to the product due to lightning and power line surges.

Do not overload wall outlets, extension cords, or convenience receptacles on other equipment as this can result in a risk of fire or electric shock.

Never push objects of any kind into this product through openings as they may touch dangerous voltage points or short out parts that could result in a fire or electric shock. Never spill liquid of any kind on the product.

Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltages and other hazards. Refer all service to qualified service personnel.

Unplug this product from the wall outlet and refer service to qualified service personnel under the following conditions:

a) When the power supply cord or plug is damaged. b) If liquid has been spilled, or objects have fallen on the product.

c) If the product has been exposed to rain or water. d) If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the Operation Manual, as an improper adjustment of controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation.

e)If the product has been dropped or damaged in any way.

f ) When the product exhibits a distinct change in

performance – this indicates a need for service.

When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or with same characteristics as the original part. Unauthorized substitutions may result in fire, electric shock, or other hazards.

Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition.

The product should be placed more than one foot away from heat sources such as radiators, heat registers, stoves, and other products (including amplifiers) that produce heat.

When connecting other products such as VCR’s, and personal computers, you should turn off the power of this product for protection against electric shock.

Use only the accessory cord designed for this product to prevent shock.

The power supply voltage rating of this product is AC 120 V, the power cord attached conforms to the following power supply voltage. Use only the power cord designated by our dealer to ensure Safety and EMC. When it is used by other power supply voltage, power cable must be changed.

Ensure that the power cable used for the projector is the correct type for the AC outlet in your country. Consult your product dealer.

*DO NOT allow any unqualified person to install the unit.

Be sure to ask your dealer to install the unit since special technical knowledge and skills are required for installation and connection to multiple devices.

If installation is performed by an unqualified person, it may cause personal injury or electrical shock.

iv

Image 4
Contents DVP1500 DVP1500 Setup Setting Display ProfilesQuick Start Instructions ConnectionsSafety Precautions Safety PrecautionsImportant Safeguards FCC Information U.S.A. onlyDo not allow any unqualified person to install the unit Table of Contents Installation InstallationConnecting Hdtv Satellite Receivers System Firmware Setup SetupSetup Menu Functions Set ScanrateOn Screen Display OSD IR Remote OSD OperationIR Remote / OSD OSD / Operating Instructions InputInput Picture Display RS232 Instructions Available PatternsOperating Instructions / RS232 Used for day-to-day operation RS232 CodesUSE only by Qualified Technician DVD Operation Commands Test Pattern Help Menu Help MenusSpecifications RS-232 AsciiPlaying recordable CDs DVDMP3 compatibility information Remote Control Number buttons 1-9, 0, +10 Press OPEN/CLOSE on the front panel Load a discPress Play on the front panel Select the item you want to viewChapter Track Skip Forward Press the Power button on the small When setting up for the first timePress Setup Press Stop onceDVD Adjusting the Dynamic Range Audio Soundtrack DVD Page DVD S-VIDEO Output is not Available with the NRS-DCS DVD Press Audio repeatedly to select the desired language Settings EnglishFrançais English Deutsch Italiano Español DVD When Other is selected Language code list can be found onUse the cursor buttons to select Other and press Enter Press Enter to set the new languageSettings Subtitle Language English French Chinese German Other Italian SpanishOff Assist Subtitle Selected SubtitleTo return to normal playback Press Pause 8, STEP/SLOW e or EPress Pause 8, STEP/SLOW e or E Press STEP/SLOW e or E Press Search Mode repeatedly to select the type of search When performing a time searchPress Play Super VCD/Video CDUsing the MP3 Navigator MP3 Navigate using the following controlsTo cancel repeat play To cancel A-B repeat playPress Random once, then press Enter or Play Press Random twice, then press Enter orPress Enter or Play To program a pause in a programTo delete a number To insert a numberTo confirm the contents of a program DVD/Super VCD/Video CD/CDPress Program To add to a programToNotesconfirm the contents of a program Press Program to enter the MP3 Program screenUse the number buttons to enter a three- digit track number To save a program in memory DVDPress Last Memory during play Press Last Memory while in the stop modeLoad a disc that has a Last Memory point memorized DVD DVD DVD Viewing Disc Information DVD DVD Faroudja DVD Using the wrong remote Faroudja Limited Warranty