DVD
Resuming playback from where you stopped
– DVD/Super VCD/Video CD
Use the resume feature to restart playback from the point that the disc was stopped last time.
This features cannot be used with MP3s and CDs.
Press STOP once.
The display shows “RESUME” and the stop position is memorized.
•The resume position remains memorized as long as the disc is in the player — even if you switch the power off.
•Pressing STOP twice causes the disc to return to
the beginning when PLAY is pressed again. The display shows the disc type (DVDs or Super VCDs/ Video CDs).
Press PLAY .
Playback starts from the resume position.
Notes
•The actual restart position may be slightly before or after the resume position.
•If you want to remove the disc, but still want to resume playback from the last stopped position, use the LAST MEMORY feature instead (page 48).
Stopping Playback and Switching Power Off
– DVD/Super VCD/Video CD/CD/MP35
1 | Press STOP ( on the front panel). |
| Playback stops. |
2 | Press OPEN/CLOSE ( on the front panel). |
| The disc tray comes out. |
3 | Remove the disc. |
4 | Press the Power button on the small |
| remote or the front panel |
The disc tray goes back in.
Adjusting Audio
and Video
Settings
Using the Setup Screen
Menus
The procedure on this page describes how to operate the menus on the Setup screen. These menus are used to set and adjust a number of system settings. The various functions that can be adjusted are covered throughout this manual. The procedure on this page provides a basic outline for using the Setup screen menus.
When setting up for the first time
It is recommended to set up player using the Setup Navigator (page 17 ). If you selected [Auto Start Off] when the Setup Navigator appeared, you may still set up the player using the Setup Navigator in the General menu screen.
If you choose not to use the Setup Navigator, be sure to make the necessary settings in the Setup screen Audio 1, Audio 2, Video 1, Video 2 and Language menus as described on the following pages.
Some DVDs start playing automatically when loaded in the player. If a DVD has been loaded, be sure to press STOP before proceeding.
1 NOT ACTIVE
2 Press SETUP.
The Setup screen appears.
Example |
|
|
Audio1 A2 Video1 V2 Language | General |
|
Audio DRC — Off |
|
|
Dolby Digital Out — Dolby Digital |
| |
DTS Out — Off |
|
|
96kHz PCM Out — 96kHz 48kHz |
| |
MPEG Out — MPEG PCM |
| |
Setup audio |
|
|
Digital output format/tone adjust |
| |
Move | SETUP | Exit |
20