Lenovo 7523 Diagnostic Error Code FRU/Action 011-199-XXX, 011-2XX-XXX External serial device

Diagnostic Error Code	FRU/Action
011-199-XXX	1.	Go to “Undetermined problems” on page
Serial port test failed, cause unknown
		80
	2. Flash the system and re-test. See
		“Updating (flashing) the BIOS from a
		disc” on page 380
	3. Replace component under function test
011-2XX-XXX	1.	External serial device
Serial port signal failure
	2.	System board
014-000-XXX	No action
Parallel port Interface Test Passed
014-001-XXX	1.	Remove external parallel device, if
Parallel port Presence
		present
	2. Run setup, enable port
	3.	System board
014-002-XXX	System board
014-003-XXX
Parallel port Timeout/Parity error
014-013-XXX	System board
014-014-XXX
Parallel port Control Signal/Loopback test
failure
014-015-XXX	1.	Wrap plug
Parallel port External Loopback failure
	2.	System board
014-027-XXX	1.	Run Setup, enable port
Parallel port Configuration/Setup error
	2.	Flash the system. See “Updating
		(flashing) the BIOS from a disc” on page
		380
	3.	System board
014-03X-XXX	System board
014-04X-XXX
Parallel port failure
014-195-XXX	Information only
Parallel port Test aborted by user	Re-start the test, if necessary
014-196-XXX	1.	Press F3 to review the log file
Parallel port test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
014-197-XXX	1.	Make sure the component that is called
Parallel port test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2. Re-run test
	3. Replace the component that is called out
		in warning statement
	4. Replace the component under test

62Hardware Maintenance Manual