Lenovo 7522 005-012-XXX, 005-013-XXX, XXX Video Ram, XXX Video card, if installed, XXX Run Setup

Diagnostic Error Code	FRU/Action
005-010-XXX	1.	Video card, if installed
005-011-XXX
	2.	System board
005-012-XXX
005-013-XXX
Video Signal failure
005-016-XXX	1.	Video Ram
Video Simple Pattern
	2.	Video card, if installed
test failure
	3.	System board
005-024-XXX	1.	Video card, if installed
Video Addressing test failure
	2.	System board
005-025-XXX	1.	Video card, if installed
Video Checksum Value error
	2.	System board
005-027-XXX	1.	Run Setup
Video Configuration/Setup error
	2.	Video drivers update
	3.	Video card, if installed
	4.	System board
005-031-XXX	1.	Video cable
Video Device Cable failure
	2.	Monitor
	3.	Video card, if installed
	4.	System board
005-032-XXX	1.	Video card, if installed
Video Device Controller failure
	2.	System board
005-036-XXX	1.	Video card, if installed
Video Register error
	2.	System board
005-038-XXX	1.	Video card, if installed
System BIOS extension failure
	2.	System board
005-040-XXX	1.	Video card, if installed
Video IRQ failure
	2.	System board
005-195-XXX	Information only
Video Test aborted by user	Re-start the test, if necessary
005-196-XXX	1.	Press F3 to review the log file
Video test halt, error threshold exceeded
	2.	Re-start the test to reset the log file
005-197-XXX	1.	Make sure the component that is called
Video test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2.	Re-run test
	3.	Replace the component called out in
		warning statement
	4.	Replace the component under test

Chapter 7. Symptom-to-FRU index 59