Lenovo 7773, 7721 XXX Press F3 to review the log file, XXX Make sure the component that is called

Diagnostic Error Code	FRU/Action
175-195-XXX	Information only
Thermal Sensor(s) Test aborted by user	Re-start the test, if necessary
175-196-XXX	1.	Press F3 to review the log file
Thermal Sensor(s) test halt, error threshold
	2.	Re-start the test to reset the log file
exceeded
175-197-XXX	1.	Make sure the component that is called
Thermal Sensor(s) test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test
175-198-XXX	1.	If a component is called out, make sure
Thermal Sensor(s) test aborted
		it is connected and/or enabled
	2.	Flash the system and re-test. See
		“Updating (flashing) the BIOS from a
		disc” on page 380
	3.	Go to “Undetermined problems” on page
		80
175-199-XXX	1.	See “Undetermined problems” on page
Thermal Sensor(s) test failed, cause
		80
unknown
	2.	Flash the system and re-test. See
		“Updating (flashing) the BIOS from a
		disc” on page 380
	3.	Replace component under function test
175-250-XXX	1.	Check fans
175-251-XXX
	2.	Check Power supply voltages
Thermal Sensor(s) limit error
	3.	Microprocessor
	4.	System board
185-000-XXX	No action
Asset Security Test Passed
185-XXX-XXX	1.	Flash system
Asset Security failure
	2.	System board
185-278-XXX	1.	Assure Asset Security Enabled
Asset Security Chassis Intrusion
	2.	C2 Cover Switch
	3.	System board
201-000-XXX	No action
System Memory Test Passed
201-XXX-XXX	1.	Replace the memory module called out
System Memory error
		by the test
	2.	System board
202-000-XXX	No action
System Cache Test Passed
202-XXX-XXX	1.	Cache, if removable
System Cache error
	2.	System board
	3.	Microprocessor

Chapter 7. Symptom-to-FRU index 73