Accessing the system board components and drives
Attention
Do not open your computer or attempt any repair before reading and understanding the “Important safety information” in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to: http://www.lenovo.com/support
This section provides instructions on how to access the system board components and drives.
To access the system board components and drives:
1.Open the computer cover. See “Opening the computer cover” on page 126.
2.On some models, you might need to pivot the drive bay assembly upward and remove the hard disk drive to access the internal components. See “Replacing the hard disk drive” on page 136.
Note: Make sure you note the location of any cables that you disconnect from the drives or the system board.
Attention: Make sure the hard disk drive assembly is in the latched down position before closing the computer cover to prevent damage to the hard disk drive assembly.
Figure 41. Pivoting the drive bay assembly
Chapter 9. Replacing FRUs - 607 computers 127
