Lenovo 7611, 7721 014-199-XXX, 014-2XX-XXX External parallel device 014-3XX-XXX, XXX No action

Diagnostic Error Code	FRU/Action
014-198-XXX	1.	If a component is called out, make sure
Parallel port test aborted
		it is connected and/or enabled
	2.	Flash the system and re-test. See
		“Updating (flashing) the BIOS from a
		disc” on page 380
	3.	Go to “Undetermined problems” on page
		80
014-199-XXX	1.	Go to “Undetermined problems” on page
Parallel port test failed, cause unknown
		80
	2.	Flash the system and re-test. See
		“Updating (flashing) the BIOS from a
		disc” on page 380
	3.	Replace component under function test
014-2XX-XXX	1.	External parallel device
014-3XX-XXX
	2.	System board
Parallel port failure
015-000-XXX	No action
USB port Interface Test Passed
015-001-XXX	1.	Remove USB device(s) and re-test
USB port Presence
	2.	System board
015-002-XXX	1.	Remove USB device(s) and re-test
USB port Timeout
	2.	System board
015-015-XXX	1.	Remove USB device(s) and re-test
USB port External Loopback failure
	2.	System board
015-027-XXX	1.	Flash the system. See “Updating
USB port Configuration/Setup error
		(flashing) the BIOS from a disc” on
		page 380
	2.	System board
015-032-XXX	System board
USB port Device Controller failure
015-034-XXX	1.	Reboot the system
USB port buffer
	2.	Flash the system and re-test. See
allocation failure
		“Updating (flashing) the BIOS from a
		disc” on page 380
	3.	Run memory test
	4.	System board
015-035-XXX	1.	Remove USB device(s) and re-test
USB port Reset condition detected
	2.	System board
015-036-XXX	System board
USB port Register error
015-040-XXX	1.	Run setup and check for conflicts
USB port IRQ failure
	2.	Flash the system. See “Updating
		(flashing) the BIOS from a disc” on page
		380
	3.	System board
015-195-XXX	Information only
USB port Test aborted by user	Re-start the test, if necessary

Chapter 7. Symptom-to-FRU index 63