Lenovo 7569, 7721 Diagnostic Error Code FRU/Action 011-000-XXX No action, Present, XXX Wrap plug

Diagnostic Error Code	FRU/Action
011-000-XXX	No action
Serial port Interface Test Passed
011-001-XXX	1.	Remove external serial device, if
Serial port Presence
		present
	2. Run setup, enable port
	3.	System board
011-002-XXX	System board
011-003-XXX
Serial port Timeout/Parity error
011-013-XXX	System board
011-014-XXX
Serial port Control Signal/Loopback test
failure
011-015-XXX	1.	Wrap plug
Serial port External Loopback failure
	2.	System board
011-027-XXX	1.	Run Setup, enable port
Serial port Configuration/Setup error
	2.	Flash the system. See “Updating
		(flashing) the BIOS from a disc” on page
		380
	3.	System board
011-03X-XXX	System board
011-04X-XXX
Serial port failure
011-195-XXX	Information only
Serial port Test aborted by user	Re-start the test, if necessary
011-196-XXX	1.	Press F3 to review the log file
Serial port test halt, error threshold exceeded
	2.	Re-start the test to reset the log file
011-197-XXX	1.	Make sure the component that is called
Serial port test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2. Re-run test
	3. Replace the component that is called out
		in warning statement
	4. Replace the component under test
011-198-XXX	1.	If a component is called out, make sure
Serial port test aborted
		it is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2. Flash the system and re-test. See
		“Updating (flashing) the BIOS from a
		disc” on page 380
	3. Go to “Undetermined problems” on page
		80

Chapter 7. Symptom-to-FRU index 61