5.Remove the four screws 1 that secure the heat sink and fan assembly to the system board.
Note: Carefully remove the four screws from the system board to avoid any possible damage. The four screws cannot be removed from the heat sink and fan assembly.
Figure 15. Removing the heat sink and fan assembly
6.Lift the failing heat sink and fan assembly off the system board.
Notes:
a.You might have to gently twist the heat sink and fan assembly to free it from the microprocessor.
b.Do not touch the thermal grease while handling the heat sink and fan assembly.
7.Position the new heat sink and fan assembly on the system board so that the four screws are aligned with the holes on the system board.
Note: Position the new heat sink and fan assembly so that the heat sink and fan assembly cable is toward the microprocessor fan connector on the system board.
Chapter 8. Replacing FRUs - Tamdhu computers 99
