Lenovo 7610 XXX Make sure the component that is called, 015-199-XXX, XXX No action, XXX PCI card

Diagnostic Error Code	FRU/Action
015-196-XXX	1.	Press F3 to review the log file
USB port test halt, error threshold exceeded
	2.	Re-start the test to reset the log file
015-197-XXX	1.	Make sure the component that is called
USB port test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test
015-198-XXX	1.	If a component is called out, make sure
USB port test aborted
		it is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2.	Flash the system and re-test. See
		“Updating (flashing) the BIOS from a
		disc” on page 380
	3.	Go to “Undetermined problems” on page
		80
015-199-XXX	1.	Go to “Undetermined problems” on page
USB port test failed, cause unknown
		80
	2.	Flash the system and re-test. See
		“Updating (flashing) the BIOS from a
		disc” on page 380
	3.	Replace component under function test
018-000-XXX	No action
PCI Card Test Passed
018-0XX-XXX	1.	Riser card, if installed
PCI Card Failure
	2.	System board
018-195-XXX	1.	PCI card
PCI Card Test aborted by user
	2.	Information only
		Re-start the test, if necessary
018-196-XXX	1.	Press F3 to review the log file
PCI Card test halt, error threshold exceeded
	2.	Re-start the test to reset the log file
018-197-XXX	1.	Make sure the component that is called
PCI Card test warning
		out is connected and/or enabled. See
		Chapter 6, “Using the Setup Utility,” on
		page 49
	2.	Re-run test
	3.	Replace the component that is called out
		in warning statement
	4.	Replace the component under test

64Hardware Maintenance Manual