Appendix AError Messages, Fatal Error Messages | GE A071-0CG

Appendix A:Error Messages

This section contains a description of all error messages posted to the WESMAINT Error Log by the ANSI X3.28/SRIO DPA

A.1 Error Messages

Messages logged to the WESMAINT Error Log by the DPA will be pre-pended with a process name. This name will be one of the following:

•A071:

•E071:

•L071:

•R071:

•T071:

4.2Fatal Error Messages

Fatal error messages indicate the application is suspending due to either an invalid critical configuration parameter, or a critical process initialization sequence failed.

ANSI Application process died

Cause:

•During regular operation one of the standard operating processes has suspended.

Remedy:

•Contact the Customer Service Department to report this error.

Restricted

A071-0CG-2.02-2

Full	11

Image 23

GE A071-0CG manual Appendix AError Messages, Fatal Error Messages, Ansi Application process died

Contents

Ansi X3.28/SRIO DPA Trademark Notices Table of Contents Ansi X3.28/SRIO DPA List of Figures System Overview Xii Read Access Flags Ansi X3.28/SRIO DPA List of Tables Viii Who Should Use this Guide About this GuidePurpose of this Guide Additional Documentation Product Perspective Overview Xii Ansi X3.28/SRIO DPA Configuration Tables Configuring Tables Configuration Sequence Character Times Configuring the Main Table A071MAIN Ansi X3.28/SRIO DPA GE Energy Services Baud Rate One Character Time ms Configuring the Mapping Tables Mapping Table Configuration Parameters Log-In User B014USER Configuring Wesmaint for the Ansi X3.28/SRIO DPA Read Access Flags Ansi Application process died Appendix AError MessagesError Messages Fatal Error Messages Cant get enough memory for Ansi Application. Suspending Cant allocate rx sinksCant create required exchanges. Suspending Cant create T071 exchange Cant spawn/activate L071 process Cant set communications timersCant set configured bit rate Cant spawn/activate E071 process Invalid checksum configured Bcc or Crc Invalid AI offset configuredInvalid Analog Format configured 32 BIN, 6 or 3 BCD Invalid AO offset configured Invalid embedded response enable Yes or No Invalid DD offset configuredInvalid DI offset configured Invalid do offset configured Invalid OBJ offset configured Invalid Evnt offset configuredInvalid EV offset configured Invalid modem enable Yes or No Invalid Retransmit digital configured -1 to Invalid parity configured None, Even, OddInvalid PD offset configured Invalid Retransmit analog configured -1 to Mapped AO point not Found. Check config Invalid SYS offset configuredInvalid TM offset configured Mapped AI point not Found. Check config Missing Configuration ... Deleting Mapped DI point not Found. Check configMapped do point not Found. Check config Mapped EV point not Found. Check config Ansi X3.28/SRIO DPA Ascii Glossary of Terms WIN List of Acronyms and Abbreviations