Invalid DD offset configured | GE A071-0CG specification

ANSI X3.28/SRIO DPA
CONFIGURATION GUIDE	GE Energy Services

Invalid DD offset configured

Cause:

•The configured direct data offset is invalid.

Remedy:

•Ensure the configured DD Offset in A071MAIN is a positive value.

•Ensure the configured DD Offset is less than the Sys Offset.

Invalid destination number

Cause:

•The configured RTU address is invalid.

Remedy:

•Ensure the configured RTU Address in A071MAIN is not the broadcast address (255).

Invalid DI offset configured

Cause:

•The configured digital input offset is invalid.

Remedy:

•Ensure the configured DI Offset in A071MAIN is a positive value.

•Ensure the configured DI Offset is less than the DO Offset.

Invalid DO offset configured

Cause:

•The configured digital output offset is invalid.

Remedy:

•Ensure the configured DO Offset in A071MAIN is a positive value.

•Ensure the configured DO Offset is less than the EV Offset.

Invalid embedded response enable (Y)es or (N)o

Cause:

•The configured embedded response enable parameter is invalid.

Remedy:

•Ensure the configured Embedded Rsp in A071MAIN is either Yes (Y) or No (N).

Invalid event timeout configured

Cause:

•The configured spontaneous event timeout is invalid.

Remedy:

•Ensure the configured Spontaneous Event Timeout in A071MAIN is a positive value.

Restricted

A071-0CG-2.02-2

Full	15

Image 27

GE A071-0CG manual Invalid DD offset configured, Invalid destination number, Invalid DI offset configured

Contents

Ansi X3.28/SRIO DPA Trademark Notices Table of Contents Ansi X3.28/SRIO DPA List of Figures System Overview Xii Read Access Flags Ansi X3.28/SRIO DPA List of Tables Viii About this Guide Purpose of this GuideWho Should Use this Guide Additional Documentation Product Perspective Overview Xii Ansi X3.28/SRIO DPA Configuration Tables Configuring Tables Configuration Sequence Character Times Configuring the Main Table A071MAIN Ansi X3.28/SRIO DPA GE Energy Services Baud Rate One Character Time ms Configuring the Mapping Tables Mapping Table Configuration Parameters Log-In User B014USER Configuring Wesmaint for the Ansi X3.28/SRIO DPA Read Access Flags Ansi Application process died Appendix AError MessagesError Messages Fatal Error Messages Cant get enough memory for Ansi Application. Suspending Cant allocate rx sinksCant create required exchanges. Suspending Cant create T071 exchange Cant spawn/activate L071 process Cant set communications timersCant set configured bit rate Cant spawn/activate E071 process Invalid checksum configured Bcc or Crc Invalid AI offset configuredInvalid Analog Format configured 32 BIN, 6 or 3 BCD Invalid AO offset configured Invalid embedded response enable Yes or No Invalid DD offset configuredInvalid DI offset configured Invalid do offset configured Invalid OBJ offset configured Invalid Evnt offset configuredInvalid EV offset configured Invalid modem enable Yes or No Invalid Retransmit digital configured -1 to Invalid parity configured None, Even, OddInvalid PD offset configured Invalid Retransmit analog configured -1 to Mapped AO point not Found. Check config Invalid SYS offset configuredInvalid TM offset configured Mapped AI point not Found. Check config Missing Configuration ... Deleting Mapped DI point not Found. Check configMapped do point not Found. Check config Mapped EV point not Found. Check config Ansi X3.28/SRIO DPA Ascii Glossary of Terms WIN List of Acronyms and Abbreviations