About this Guide, Purpose of this Guide | GE A071-0CG guide

About this Guide

This guide describes, in detail, how to configure the ANSI X3.28/SRIO Data Processing Application (DPA).

Purpose of this Guide

This document describes the purpose and use of each of the configuration parameters of the ANSI X3.28/SRIO DPA. This document makes no attempt to explain how the configuration process operates, it is limited to describing the format and content of the DPA configuration only.

To configure the data mapping the user must also allow for the SPABUS Data Collection Application (DCA) to be configured in conjunction with this application. Refer to the SPABUS Configuration Guide listed in the Additional Documentation for more information on configuring the SPABUS DCA.

Who Should Use this Guide

This document is intended for use by individuals responsible for the configuration of the ANSI X3.28/SRIO DPA in GE Energy Services RTUs. These people should be familiar with the operation and maintenance of RTUs in general, but may not be familiar with the GE Energy Services family of products.

Before reading this document, you should have a basic understanding of the WESDAC hardware environment, the configuration system, the ANSI X3.28/SRIO DPA, and the SPABUS DCA.

Restricted	A071-0CG-2.02-2
Full

ix

Image 9

GE A071-0CG manual About this Guide, Purpose of this Guide, Who Should Use this Guide

Contents

Ansi X3.28/SRIO DPA Trademark Notices Table of Contents Ansi X3.28/SRIO DPA List of Figures System Overview Xii Read Access Flags Ansi X3.28/SRIO DPA List of Tables Viii About this Guide Purpose of this GuideWho Should Use this Guide Additional Documentation Product Perspective Overview Xii Ansi X3.28/SRIO DPA Configuration Tables Configuring Tables Configuration Sequence Character Times Configuring the Main Table A071MAIN Ansi X3.28/SRIO DPA GE Energy Services Baud Rate One Character Time ms Configuring the Mapping Tables Mapping Table Configuration Parameters Log-In User B014USER Configuring Wesmaint for the Ansi X3.28/SRIO DPA Read Access Flags Error Messages Appendix AError MessagesFatal Error Messages Ansi Application process died Cant create required exchanges. Suspending Cant allocate rx sinksCant create T071 exchange Cant get enough memory for Ansi Application. Suspending Cant set configured bit rate Cant set communications timersCant spawn/activate E071 process Cant spawn/activate L071 process Invalid Analog Format configured 32 BIN, 6 or 3 BCD Invalid AI offset configuredInvalid AO offset configured Invalid checksum configured Bcc or Crc Invalid DI offset configured Invalid DD offset configuredInvalid do offset configured Invalid embedded response enable Yes or No Invalid EV offset configured Invalid Evnt offset configuredInvalid modem enable Yes or No Invalid OBJ offset configured Invalid PD offset configured Invalid parity configured None, Even, OddInvalid Retransmit analog configured -1 to Invalid Retransmit digital configured -1 to Invalid TM offset configured Invalid SYS offset configuredMapped AI point not Found. Check config Mapped AO point not Found. Check config Mapped do point not Found. Check config Mapped DI point not Found. Check configMapped EV point not Found. Check config Missing Configuration ... Deleting Ansi X3.28/SRIO DPA Ascii Glossary of Terms WIN List of Acronyms and Abbreviations