Meridian Audio DVP1500 manual IR Remote OSD Operation, On Screen Display OSD, IR Remote / OSD

IR REMOTE / OSD

OSD Timer

0-255 (30 default)

LCD Timer

6-255 (40 Default)

Note: setting the timer to 5 or lower sets the LCD backlight to Always On.

Set: RS232 Echo

On (Default) /Off

Allows RSR232 characters to be sent back to the controller.

Set: Restore Factory

Are You Sure? - Press Enter Key

Use this Function only in the event that

The DVP1500 is shipped with a Infrared remote control that allows for direct access to most commands used to control the processor. Adjustments can be made by either pressing the appropriate button on the remote or by toggling through the On-Screen-Display (OSD).

This is a learning remote that contains the codes for Faroudja processors and display systems. The remote can be programmed to handle other devices as well. See the separate manual for instructions on programming this remote.

The remote has four screens with the different commands.

the processor no longer functions properly and all other system checks have been performed. This command will erase all custom settings and restore the original firmware configuration. Be sure to go back through the Setup procedure for proper operation.

The next step in the setup procedure is to align the display device. Be sure to follow all directions for setting up the display found in the display’s manual. Using a test DVD

Access OSD Menu

Select Inputs

Note: Press the DVD key two times to select

Recall Profiles

Note: To recall a profile, Press Profile + P1-P6

Press Profile + Fact Recall to reset picture level settings to the factory position.

with the Safe Area test pattern, align the image size, position and blanking first using the controls found in the display device. Only use these controls in the DVP1500 if the display device does not offer these controls or if there is not enough range.

IR REMOTE AND

OSD OPERATION

Aspect Ratio select

Image Adjustments

Number pad: allows for entering specific level numbers (Contrast + ###),

or access to added Profiles P7 & P8 (Profiles + 7 or 8).

Touch screen panel

Function / Value Keys

Store / Enter Key

ON SCREEN DISPLAY (OSD)

Accessing the OSD

•Press Menu button to bring up main Index.

•Use Function Up/Down Keys until the triangle at the top of the OSD turns yellow.

•Use the Left/Right keys to move to the next menu page. A list of available Functions will appear.

•Press Function Up/Down keys to select an adjustment.

•Use Value Left/Right keys to adjust.

The main menu drops away and a single line menu appears.

•Use the Function keys to return to the drop down menu.

•The OSD will time out after 8 seconds.

Note: Unused inputs can be deactivated for simpler operation of the processor. See the Setup instructions for details.

6