10. PBIO ENABLE/DISABLE
On the ST300, press the [PBIO] key to enable or disable PBIO. When disabled, the ST300 will ignore all Pbus commands. When enabled, the ST300 will respond to all Pbus commands.
When enabled and Pbus commands are received, the key's LED will flash.
11. TRIGGERS FROM THE PRODUCTION SWITCHER
Firing a trigger, using either the Timeline or Run function on the production switcher, causes the ST300 to put the Video Server into the following modes, based upon the trigger value:
GRASS VALLEY GROUP
Trigger Value | Mode | |
0 | Play |
|
1 | Recue to beginning of clip | |
2 | ||
3 | Reverse Play | |
4 | Still Frame | |
5 | None | |
6 or greater | Play | |
SONY |
|
|
Trigger Value | Mode | |
0 | Recue | to beginning of clip |
1 | Play | |
2 | ||
3 | Reverse Play | |
4 | Still Frame | |
5 | None | |
6 or greater | Play | |
To control more than one VTR, enable the Peripheral Device Address for the required VTRs. The Trigger will be sent to the enabled devices.
OR
GANG the required VTRs on the ST300. See the Menu Table for GANG instructions. Enable the Peripheral Device Address for one of the GANGed VTRs. The Trigger will be sent to the enabled VTR. The other VTRs in the GANG will perform the same action.
9