11.Run wires from the back of the dome unit to the roof edge, then along edge to location where wiring will be fed into the vehicle. (If installing an optional second receiver, run auxiliary coax to location where it will enter the vehicle.) Secure wiring to roof every 12- 18 inches (Fig. 10).
12.Drill 3/4” hole through the roof and into the cabinet where receiver is stored. Feed wiring down through hole. Seal opening with roof compatible sealant so that it is entirely waterproof (inside and outside of the 3/4” hole). Repeat for optional second receiver (Fig. 10).
Fig. 10
TYPICAL ROOF INSTALLATION - OVERHEAD VIEW
IMPORTANT! Sealant must be roof compatible.
13. Remove blue protective sheet and red “position to rear” sticker from the dome unit.
Page 9