King Controls 9754 operating instructions Dome Installation

Page 9

Fig. 7

Example of truck installation using bracket.

See bracket instructions for proper installation.

IMPORTANT! The dome unit MUST be mounted to the air ride cab: NEVER to any structure mounted directly to the frame.

DOME INSTALLATION

IMPORTANT! Make sure shipping restraints are removed from bottom of dome unit and plugs are inserted in holes (Fig. 5, Page 5).

s

Cable connections must ALWAYS be positioned facing the rear of vehicle.

 

5.Place dome unit on installation location chosen using the criteria discussed in the previous section. Shipping restraints must be removed, plugs must be inserted in holes (Fig. 5, Page 5), and cable connections must be positioned facing rear of vehicle.

6.The dome unit must be positioned so that both feet on each side of the vehicle are equal distances from the roof edge. This should be checked by measuring the distance from each foot to the roof edge. Confirm that these measurements are equal (Fig. 8).

Fig. 8

IMPORTANT!

Cable connections must always face REAR of vehicle.

IMPORTANT! The dome should never be mounted so that it is tilted more than two degrees in any direction.

Page 7

Image 9
Contents In-Motion Satellite System Page Table of Contents Section IntroductionDefinition of Terms Installation KIT ContentsTools and Materials Required Keep Rubber Plugs Height Dome LocationMinimum Distance To Dome EdgeDome Installation External Wiring IMPORTANT! Sealant must be roof compatible Internal Wiring This page intentionally left blank Satellite Switching Mode Satellite ConfigurationDirectv Satellite ServiceStatus Light System Status Stationary OperationIN-MOTION Operation Must Show SW21 Dish 500 for Dish NetworkDirectv Directv Receiver ConfigurationIN-MOTION TroubleshootingRain Fade MaintenanceLimited Warranty