King Controls 9754 operating instructions Internal Wiring

Page 12

INTERNAL WIRING

IMPORTANT: The connection between the dome unit and the receiver must be a direct connection with no devices in between. Any other devices should be downstream from the receiver.

14.Inside vehicle, connect main coax from the dome unit directly to the “satellite in” port of the main receiver. Do not go through an “A-B” or any other switch, box, or booster. Connect auxiliary coax directly to optional second receiver.

IMPORTANT: Power connection must be a non-shared circuit. Excessive current draw on the circuit will cause the unit to operate improperly. Power and ground connections must be made after the wires are connected to the dome unit.

15.Connect red and black two conductor wire to a power source and ground. Red connects to +12 volts, and black connects to ground.

16.Plug phone style controller cable into Controller.

Page 10

Image 12
Contents In-Motion Satellite System Page Table of Contents Introduction SectionDefinition of Terms Installation KIT ContentsTools and Materials Required Keep Rubber Plugs Dome Location HeightMinimum Distance To Dome EdgeDome Installation External Wiring IMPORTANT! Sealant must be roof compatible Internal Wiring This page intentionally left blank Satellite Configuration Satellite Switching ModeSatellite Service DirectvStationary Operation Status Light System StatusIN-MOTION Operation Dish 500 for Dish Network Must Show SW21Directv Receiver Configuration DirectvTroubleshooting IN-MOTIONMaintenance Rain FadeLimited Warranty