SECTION 3 | INSTALLATION |
| |
|
|
TOOLS AND MATERIALS REQUIRED:
-drill and drill bit set
-tape measure
-7/16” open end wrench (coax connections)
-adhesive sealant (compatible with roof material)
-appropriate fasteners to install all components and wiring
-5/32” allen wrench, channel lock or pliers (to remove shipping bolts)
-wire cutter (to remove shipping tie strap)
-#1844 King Controls Installation and Diagnostic Keypad
KIT CONTENTS:
1. Unpack and identify all components (Fig. 4).
Fig. 4
KIT CONTENTS
STATIONARY OPERATION
1.Turn TV and satellite receiver ON.
2.Press and hold ON/SEARCH button for 3 FULL SECONDS.
Expect Status Light |
|
RED | Searching |
GREEN - flashing . . . . | potential satellite found |
GREEN - steady | Search Complete |
Note: If the status light flashes orange after completing the search process, there is something likely blocking the satellite signal from reaching the antenna (tees, buildings, etc).
2.If the search is complete and your programming does not appear, press the reset button on your DIRECTV receiver. If using Dish Network, hold the receiver power button in for 10 seconds to reset the receiver.
2. Select your desired channel and enjoy.
Note: To use the automatic satellite switching feature, DO NOT turn the
Page 4